[Home] [This version is outdated, a new version is here]
*Title...
*Search:...
*Read Me/FAQ/General Info...
*_IBM...
*ACC Micro...
*ALD...
*ALi...
*AMD . . . . . . . [no datasheets, some info]...
*Chips & Technologies...
*Contaq  . . . . . [no datasheets, some info]...
*Efar Microsystems [no datasheets, some info]...
*ETEQ...
*Faraday...
*Forex . . . . . . [List only, no datasheets found]...
*Intel...
**440 series:
***440FX (Natoma)       05/06/96...
***440LX (Balboa)       08/27/97...
***440BX (Seattle)      c:Apr'98...
***440DX (?)            c:?...
***440EX (?)            c:Apr'98...
***440GX (Marlinespike) 06/29/98...
***440ZX & 440ZX-66 (?) 01/04/99...
***440ZX-M (?)          05/17/99...
***440MX (Banister)     05/17/99...
**450NX  (?)            06/29/98:...
**?????  (Profusion)    c:99...
**800 series...
*Headland/G2...
*HMC (Hulon Microelectronics)...
*Logicstar...
*Motorola...
*OPTi...
*PC CHIPS/Amptron/Atrend/ECS/Elpina/etc...
*SIS...
*Symphony...
*TI (Texas Instruments)...
*UMC...
**UM82C088     PC/XT Integration Chip                              <91
***Info:...
***Configurations:...
***Features:
o   Fully IBM-PC/XT compatible
o   82C84 Clock generator with 2 clock-inputs to generate the CPU 
    clock. These are 14.318 MHz and 30 MHz which will support 4.77 MHz
    and 10 MHz CPU clocks with 1/3 duty cycle.
o   82C88 Bus Controller
o   82C37 4 channel DMA controller, channel is used for DRAM refresh
o   82C59 8 channel interrupt controller, level is used for system 
    time base, and level 1 for keyboard input 
o   82C53 3 channel timer, channel is used for system time base, 
    channel 1 for DRAM refresh, and channel 2 for speaker audio
o   82C55 Peripheral l/O r used for keyboard interface and system 
    configuration switch (same as the PC/XT)
o   74322 Keyboard interface, supports PC/XT type keyboard
o   74280 Parity check and generator
o   74670 4 bit page register for DMA
o   Wait state logic
o   NMI control logic
o   ROM decoder for one 2764 and one 27256
o   RAM decoder for 4164 or 41256 DRAM
o   H/W and S/W CPU speed change and indicator
o   Built-in delay line for RAS, CAS
o   Low power consumption: less than 300 mW at 10 MHz CPU speed
o   Small PCB size: 100 pin plastic Flat package

**UM82C230     286AT MORTAR Chip Set                               <91...
**UM82C210     386SX/286 AT Chip Set                               <91
***Info:...
***Configurations:...
***Features:...
**UM82C3xx     Twinstar & UM82C336F/N & UM82C39x [no datasheet]      ?...
**UM82C380     386 HEAT PC/AT Chip Set                             <91...
**UM82C480     386/486 PC Chip Set                                 c91...
**UM82C493/491 ??????????????? [no datasheet]                        ?...
**UM8498/8496  486 VL Chipset  "Super Energy Star Green"[no dsheet]c94...
**UM8881/8886  HB4 PCI Chipset "Super Energy Star Green"[no dsheet]c94...
**UM8890       Pentium chipset [no datasheet]                        ?...
**
**Support Chips:
**UM82152      Cache Controller (AUStek A38152 clone)              <91...
**UM82C852     Multi I/O For XT                                    <91...
**UM82C206     Integrated Peripheral Controller                    <91...
**UM82c45x     Serial/Parallel chips                                 ?...
**Other chips:...
*Unresearched:...
*VIA...
*VLSI...
*Western Digital...
*Winbond...
**W83977EF        WINBOND I/O (Multi I/O)                          <98
***Info:
GENERAL DESCRIPTION

The W83977EF  is an evolving  product from Winbond's most  popular I/O
chip W83877F --- which integrates  the disk drive adapter, serial port
(UART),  IrDA  1.0  SIR,  parallel port,  configurable  plugand-  play
registers for  the whole chip  --- plus additional  powerful features:
ACPI,  8042 keyboard controller  with PS/2  mouse support,  14 general
purpose  I/O  ports,  full  16-bit address  decoding,  OnNow  keyboard
Wake-Up, OnNow mouse Wake-Up.

The disk  drive adapter  functions of W83977EF  include a  floppy disk
drive  controller compatible  with the  industry standard  82077/ 765,
data  separator, write  pre-compensation circuit,  decode  logic, data
rate selection,  clock generator,  drive interface control  logic, and
interrupt and DMA  logic. The wide range of  functions integrated onto
the  W83977EF greatly reduces  the number  of components  required for
interfacing with floppy disk  drives. The W83977EF supports four 360K,
720K, 1.2M, 1.44M, or 2.88M disk drives and data transfer rates of 250
Kb/s, 300 Kb/s, 500 Kb/s,1 Mb/s, and 2 Mb/s.

The  W83977EF  provides  two  high-speed  serial  communication  ports
(UARTs),  one of  which supports  serial Infrared  communication. Each
UART includes  a 16-byte send/receive  FIFO, a programmable  baud rate
generator,  complete   modem  control  capability,   and  a  processor
interrupt system. Both UARTs provide legacy speed with baud rate up to
115.2k bps and  also advanced speed with baud rates  of 230k, 460k, or
921k bps which support higher speed modems.

The   W83977EF  supports   one  PC-compatible   printer   port  (SPP),
Bi-directional  Printer port  (BPP)  and also  Enhanced Parallel  Port
(EPP) and  Extended Capabilities Port (ECP). Through  the printer port
interface pins,  also available are: Extension FDD  Mode and Extension
2FDD  Mode allowing  one  or two  external  floppy disk  drives to  be
connected.

The   configuration  registers   support   mode  selection,   function
enable/disable, and  power down function  selection.  Furthermore, the
configurable  PnP  features  are  compatible  with  the  plug-and-play
feature demand  of Windows 95, which makes  system resource allocation
more efficient than ever.

W83977EF  provides   functions  that  complies   with  ACPI  (Advanced
Configuration and  Power Interface), which includes  support of legacy
and ACPI power  management through SMI or SCI  function pins. W83977EF
also  has auto  power  management to  reduce  power consumption.   The
keyboard controller is based on 8042 compatible instruction set with a
2K  Byte programmable  ROM  and  a 256-Byte  RAM  bank. Keyboard  BIOS
firmware are available with optional AMIKEY-2, Phoenix MultiKey/42, or
customer code.

The W83977EF provides  a set of flexible I/O  control functions to the
system designer through a set of General Purpose I/O ports. These GPIO
ports may  serve as  simple I/O or  may be individually  configured to
provide a predefined alternate function.

The W83977EF  also supports Power-loss  control, and makes  the system
never miss to detect any Wake-Up event provided by the chipset such as
INTEL PIIX4.

I/O  space   resource  are  flexible   to  adjust  to  meet   ISA  PnP
requirement. Moreover  W83977EF is made  to meet the  specification of
PC98's requirement in the power management: ACPI and DPM (Device Power
Management).

Another  benifit is that  W83977EF is  of the  same pin  assignment of
W83977AF,  W83977F, W83977TF,  W83977ATF. Thus  makes the  design very
flexible.

***Versions:...
***Features:...
**W83977ATF       WINBOND I/O (Multi I/O)                          <98...
**
**Disk Controller:
**W83759/A/F/AF   Advanced VL-IDE Disk Controller                  <96...
**W83769          Local Bus IDE Solution                           <94...
**
**UARTS:
**W86C250A  UART (equivalent of INS8C250A) [no datasheet]
**W86C450/P Universal Asynchronous Receiver/Transmitter         <Jul89...
**W86C451   I/O controller for IBM PC/AT/XT                     <Jul89...
**W86C452   I/O controller for IBM PC/AT                         Jul89...
**W86C456   I/O controller [no datasheet]                            ?
**W860551/P UART with FIFO and Printer Port Controller             <94...
**
**Other:...
*ZyMOS...
*General Sources:...

(c) Copyright mR_Slugs Warehouse - All rights Reserved