[Home] [This version is outdated, a new version is here]
*Title...
*Search:...
*Read Me/FAQ/General Info...
*_IBM...
*ACC Micro...
*ALD...
*ALi...
*AMD . . . . . . . [no datasheets, some info]...
*Chips & Technologies...
*Contaq . . . . . [no datasheets, some info]...
*Efar Microsystems [no datasheets, some info]...
*ETEQ...
*Faraday...
*Forex . . . . . . [List only, no datasheets found]...
*Intel...
**????? (Profusion) c:99
Chips:
Memory Access Controller (MAC)
Data Interface Buffer (DIB)
CPUs: 8x P-III Xeon Oct
DRAM Types: SDRAM PC100 2-way Interleave dual channel
Max Mem: 32GB
ECC/Parity: ECC
AGP speed: N/A
Bus Speed: 100
PCI Clock/Bus: 1/3 PCI-66/64
**800 series...
*Headland/G2...
**HT22 386SX/286 Single Chip (25 MHz) c:Sep91
***Info:
The HT22 is an advanced PC/AT compatible, single-chip 80386SX/80286
system design solution. This highly integrated single chip allows
simple, low cost system design options while featuring high perfor-
mance, low power consumption, and minimum board space require-
ments. Advanced memory management features include support for page
mode, 2 or 4-way interleaving in both pipelined and non-pipelined
modes. The EMS 4.0 hardware implementation features dual sets of 32
registers with full context support for highest performance
optimization of extended local memory accesses. An advanced EMS
hardware write-protect option has been added for maximum EMS 4.0
compatibility. The HTZ2 supports 256K, 1M and 4MB DRAMs in 1 by 1 and
1 by 4 device configurations for up to 20MB of on-board system memory.
16MB is addressed directly by system resources, the remainder
addressed by the EMS mode.
A flexible Shadow RAM option for System and Video BIOS as well as 8-
16-bit BIOS options adds to overall design versatility.
A complete PC/AT compatible system with advanced features may be
implemented with minimal external support logic. The HT22 performs all
CPU and peripheral support functions in a single chip. Integrated
device functions include DMA Controllers, a Memory Mapper, Timers,
Counters, Interrupt Controllers, a Bus Controller and all supporting
circuitry for PC core logic requirements. The chip also contains all
the necessary address buffers, data transceivers, memory drivers,
parity checking and supporting circuitry for a complete high
performance computer solution. An asynchronous AT Bus clock allows
for a constant 8MHz Bus clock rate for highest bus device compat-
ibility as defined in IEEE Spec P996. This device is packaged in a
208-pin Plastic Quad Flat Pack.
***Configurations:...
***Features:...
**HT25 3-volt Core Logic for 386SX c:Dec92...
**HT35 Single-Chip Peripheral Controller [partial info] ?...
**HTK320 386DX Chip Set c:Sep91...
**HTK340 "Shasta" 486 Chip Set c:Jun92...
**Support Chips:
**HT44 Secondary Cache c:Jun92...
**Other:...
*HMC (Hulon Microelectronics)...
*Logicstar...
*Motorola...
*OPTi...
*PC CHIPS/Amptron/Atrend/ECS/Elpina/etc...
*SIS...
*Symphony...
*TI (Texas Instruments)...
*UMC...
*Unresearched:...
*VIA...
*VLSI...
*Western Digital...
*Winbond...
**W83977EF WINBOND I/O (Multi I/O) <98
***Info:
GENERAL DESCRIPTION
The W83977EF is an evolving product from Winbond's most popular I/O
chip W83877F --- which integrates the disk drive adapter, serial port
(UART), IrDA 1.0 SIR, parallel port, configurable plugand- play
registers for the whole chip --- plus additional powerful features:
ACPI, 8042 keyboard controller with PS/2 mouse support, 14 general
purpose I/O ports, full 16-bit address decoding, OnNow keyboard
Wake-Up, OnNow mouse Wake-Up.
The disk drive adapter functions of W83977EF include a floppy disk
drive controller compatible with the industry standard 82077/ 765,
data separator, write pre-compensation circuit, decode logic, data
rate selection, clock generator, drive interface control logic, and
interrupt and DMA logic. The wide range of functions integrated onto
the W83977EF greatly reduces the number of components required for
interfacing with floppy disk drives. The W83977EF supports four 360K,
720K, 1.2M, 1.44M, or 2.88M disk drives and data transfer rates of 250
Kb/s, 300 Kb/s, 500 Kb/s,1 Mb/s, and 2 Mb/s.
The W83977EF provides two high-speed serial communication ports
(UARTs), one of which supports serial Infrared communication. Each
UART includes a 16-byte send/receive FIFO, a programmable baud rate
generator, complete modem control capability, and a processor
interrupt system. Both UARTs provide legacy speed with baud rate up to
115.2k bps and also advanced speed with baud rates of 230k, 460k, or
921k bps which support higher speed modems.
The W83977EF supports one PC-compatible printer port (SPP),
Bi-directional Printer port (BPP) and also Enhanced Parallel Port
(EPP) and Extended Capabilities Port (ECP). Through the printer port
interface pins, also available are: Extension FDD Mode and Extension
2FDD Mode allowing one or two external floppy disk drives to be
connected.
The configuration registers support mode selection, function
enable/disable, and power down function selection. Furthermore, the
configurable PnP features are compatible with the plug-and-play
feature demand of Windows 95, which makes system resource allocation
more efficient than ever.
W83977EF provides functions that complies with ACPI (Advanced
Configuration and Power Interface), which includes support of legacy
and ACPI power management through SMI or SCI function pins. W83977EF
also has auto power management to reduce power consumption. The
keyboard controller is based on 8042 compatible instruction set with a
2K Byte programmable ROM and a 256-Byte RAM bank. Keyboard BIOS
firmware are available with optional AMIKEY-2, Phoenix MultiKey/42, or
customer code.
The W83977EF provides a set of flexible I/O control functions to the
system designer through a set of General Purpose I/O ports. These GPIO
ports may serve as simple I/O or may be individually configured to
provide a predefined alternate function.
The W83977EF also supports Power-loss control, and makes the system
never miss to detect any Wake-Up event provided by the chipset such as
INTEL PIIX4.
I/O space resource are flexible to adjust to meet ISA PnP
requirement. Moreover W83977EF is made to meet the specification of
PC98's requirement in the power management: ACPI and DPM (Device Power
Management).
Another benifit is that W83977EF is of the same pin assignment of
W83977AF, W83977F, W83977TF, W83977ATF. Thus makes the design very
flexible.
***Versions:...
***Features:...
**W83977ATF WINBOND I/O (Multi I/O) <98...
**
**Disk Controller:
**W83759/A/F/AF Advanced VL-IDE Disk Controller <96...
**W83769 Local Bus IDE Solution <94...
**
**UARTS:
**W86C250A UART (equivalent of INS8C250A) [no datasheet]
**W86C450/P Universal Asynchronous Receiver/Transmitter <Jul89...
**W86C451 I/O controller for IBM PC/AT/XT <Jul89...
**W86C452 I/O controller for IBM PC/AT Jul89...
**W86C456 I/O controller [no datasheet] ?
**W860551/P UART with FIFO and Printer Port Controller <94...
**
**Other:...
*ZyMOS...
*General Sources:...
(c) Copyright mR_Slugs Warehouse - All rights Reserved