[Home] [This version is outdated, a new version is here]
*Title...
*Search:...
*Read Me/FAQ/General Info...
*_IBM...
*ACC Micro...
*ALD...
*ALi...
*AMD . . . . . . . [no datasheets, some info]...
*Chips & Technologies...
*Contaq  . . . . . [no datasheets, some info]...
*Efar Microsystems [no datasheets, some info]...
*ETEQ...
*Faraday...
*Forex . . . . . . [List only, no datasheets found]...
*Intel...
**?????  (Profusion)    c:99
Chips:         
Memory Access Controller (MAC)  
Data Interface Buffer (DIB)
CPUs:          8x P-III Xeon Oct
DRAM Types:    SDRAM PC100 2-way Interleave dual channel
Max Mem:       32GB
ECC/Parity:    ECC
AGP speed:     N/A
Bus Speed:     100
PCI Clock/Bus: 1/3 PCI-66/64



**800 series...
*Headland/G2...
*HMC (Hulon Microelectronics)...
*Logicstar...
*Motorola...
*OPTi...
*PC CHIPS/Amptron/Atrend/ECS/Elpina/etc...
*SIS...
**5591/5592/5595 (David)   Pentium PCI A.G.P. Chipset        <01/09/98
***Info:
The SiS5591/5592  SiS5595 glueless P5  A.G.P. chipset provides  a high
performance/cost index  Desktop/Mobile solution for  the Intel Pentium
P54C/P55C, AMD K5/K6, and Cyrix M1/M2 A.G.P. system.

The SiS5591/SiS5592  A.G.P./PCI controller integrated  the Host-to-PCI
bridge, the L2 cache  controller, the DRAM controller, the Accelerated
Graphics  Port interface,  and the  PCI IDE  controller. The  L2 cache
controller can  support up to 1  M P.B. SRAM, and  the DRAM controller
can  support EDO/FP/SDRAM memory  up to  768 MB  with optional  ECC or
parity check  function. The  A.G.P. 1.0 compliance  interface supports
both  1X, and  2X speed  mode with  sideband address  capability.  The
built-in fast  PCI IDE  controller supports the  ATA PIO/DMA,  and the
Ultra DMA/33 functionality.

SiS5591  and SiS5592  have some  pin-out switching  to  facilitate the
main-board layout.  SiS5591 pin  assignment is based  on the  ATX form
factor,  and  SiS5592  pin  assignment   is  based  on  the  NLX  form
factor. Beside  the pin-out switching, SiS5591 and  SiS5592 is totally
the same on the internal logic circuit.

The SiS5595 PCI  system I/O integrates the PCI-to-ISA  bridge with the
DDMA,  and  Serial  IRQ  capability,  the ACPI/Legacy  PMU,  the  Data
Acquisition  Interface, the Universal  Serial Bus  host/hub interface,
and the ISA  bus interface which contains the  ISA bus controller, the
DMA controllers,  the interrupt controllers,  and the Timers.  It also
integrates the Keyboard controller, and the Real Time Clock (RTC). The
built-in USB controller,  which is fully compliant to  OHCI (Open Host
Controller  Interface),  provides two  USB  ports  capable of  running
full/low speed USB devices.  The Data Acquisition Interface offers the
ability of monitoring and reporting the environmental condition of the
PC. It could  monitor 4 positive analogue voltage  inputs, 2 Fan speed
inputs, and one temperature input.


***Configurations:...
***Features:...
**5596/5513      (Genesis) Pentium PCI Chipset               <03/26/96...
**5597/5598      (Jedi)    Pentium PCI/ISA Chipset           <04/15/97...
**530/5595       (Sinbad) Host, PCI, 3D Graphics & Mem. Ctrl.<11/10/98...
**540            (Spartan) Super7 2D/3D Ultra-AGP Single C.S.<11/30/99...
**55x            SoC (System-on-chip)                        <03/14/02...
**
**Support chips:
**85C206     Integrated Peripheral Controller [no datasheet]         ?...
**5595       Pentium PCI System I/O                          <12/24/97...
**950        LPC I/O                                         <07/16/99...
**Other:...
**PII/III/Pro...
**Athlon etc...
*Symphony...
*TI (Texas Instruments)...
*UMC...
*Unresearched:...
*VIA...
*VLSI...
*Western Digital...
*Winbond...
**W83977F/G/AF/AG WINBOND I/O (Multi I/O)                          c97
***Info:...
***Versions:...
***Features:
General
o  Plug & Play 1.0A Compliant
o  Support 13 IRQs, 4 DMA channels, full 16-bit addresses decoding
o  Capable of ISA Bus IRQ Sharing
o  Compliant with Microsoft PC97 Hardware Design Guide
o  Support DPM (Device Power Management), ACPI
o  Programmable configuration settings
o  24 or 14.318 Mhz clock input

FDC
o  Compatible with IBM PC AT disk drive systems
o  Variable write pre-compensation with track selectable capability
o  Support vertical recording format
o  DMA enable logic
o  16-byte data FIFOs
o  Support floppy disk drives and tape drives
o  Detects all overrun and underrun conditions
o  Built-in address mark detection circuit to simplify the read 
   electronics
o  FDD anti-virus functions with software write protect and FDD write 
   enable signal (write data signal was forced to be inactive)
o  Support up to four 3.5-inch or 5.25-inch floppy disk drives
o  Completely compatible with industry standard 82077
o  360K/720K/1.2M/1.44M/2.88M format; 250K, 300K, 500K, 1M, 2M bps 
   data transfer rate
o  Support 3-mode FDD, and its Win95 driver

UART
o  Two high-speed 16550 compatible UARTs with 16-byte send/receive 
   FIFOs
o  3rd UART with 32-byte send/receive FIFO is supported for IR 
   function [W83977AF/AG only]
o  MIDI compatible
o  Fully programmable serial-interface characteristics:
   - 5, 6, 7 or 8-bit characters
   - Even, odd or no parity bit generation/detection
   - 1, 1.5 or 2 stop bits generation
o  Internal diagnostic capabilities:
   - Loop-back controls for communications link fault isolation
   - Break, parity, overrun, framing error simulation
o  Programmable baud generator allows division of 1.8461 Mhz and 
   24 Mhz by 1 to (2^16-1)
o  Maximum baud rate up to 921k bps for 14.769 Mhz and 1.5M bps 
   for 24 Mhz

Infrared
o  Support IrDA version 1.0 SIR protocol with maximum baud rate up to 
   115.2K bps
o  Support SHARP ASK-IR protocol with maximum baud rate up to 57,600 
   bps
o  Support IrDA version 1.1 MIR (1.152M bps) and FIR (4M bps) protocol 
   [W83977AF/AG only]
   - Single DMA channel for transmitter or receiver
   - 3rd UART with 32-byte FIFO is supported in both TX/RX 
     transmission [W83977AF/AG only]
   - 8-byte status FIFO is supported to store received frame status 
     (such as overrun CRC error, etc.)
o  Support auto-config SIR and FIR [W83977AF/AG only]

Parallel Port
o  Compatible with IBM parallel port
o  Support PS/2 compatible bi-directional parallel port
o  Support Enhanced Parallel Port (EPP) 
   − Compatible with IEEE 1284 specification
o  Support Extended Capabilities Port (ECP) 
   − Compatible with IEEE 1284 specification
o  Extension FDD mode supports disk drive B; and Extension 2FDD mode 
   supports disk drives A and B through parallel port
o  Enhanced printer port back-drive current protection

Advanced Power Management (APM) Controlling
o  Power turned on when RTC reaches a preset date and time
o  Power turned on when a ring pulse or pulse train is detected on the 
   PHRI, or when a high to low transition on PWAKIN1, or PWAKIN2 
   input signals
o  Power turned on when PANSW input signal indicates a switch on event
o  Power turned off when PANSW input signal indicates a switch off 
   event
o  Power turned off when a fail-safe event occurs (power-save mode 
   detected but system is hung up)
o  Power turned off when software issues a power off command

Keyboard Controller
o  8042 based with optional F/W from AMIKKEY-2, Phoenix MultiKey/42 or 
   customer code
o  with 2K bytes of programmable ROM, and 256 bytes of RAM
o  Asynchronous Access to Two Data Registers and One status Register
o  Software compatibility with the 8042 and PC87911 microcontrollers
o  Support PS/2 mouse
o  Support port 92
o  Support both interrupt and polling modes
o  Fast Gate A20 and Hardware Keyboard Reset
o  8 Bit Timer/ Counter; support binary and BCD arithmetic
o  6, 8, 12, or 16 Mhz operating frequency (16 Mhz available only if 
   input clock rate = 14.318 Mhz)

Real Time Clock
o  27 bytes of clock, On-Now, and control/status register (14 bytes in 
   Bank 0 and 13 bytes in Bank 2); 242 bytes of general purpose RAM
o  BCD or Binary representation of time, calendar, and alarm registers
o  Counts seconds, minutes, hours, days of week, days of month, month, 
   year, and century
o  12-hour/ 24-hour clock with AM/PM in 12-hour mode
o  Daylight saving time option; automatic leap-year adjustment
o  Dedicated alarm (Alarm B) for On-Now function
o  Programmable delay-time between panel switch off and power supply 
   control
o  Software control power-off; various and maskable events to activate 
   system Power-On
o  System Management Interrupt (SMI ) for panel switch power-off event

General Purpose I/O Ports
o  14 programmable general purpose I/O ports; 6 dedicate, 8 optional
o  General purpose I/O ports can serve as simple I/O ports, interrupt 
   steering inputs, watching dog timer output, power LED output, 
   infrared I/O pins, general purpose address decoder, KBC control I/O
   pins.

Package
o  128-pin PQFP


**W83977TF        WINBOND I/O (Multi I/O)                          c97...
**W83977EF        WINBOND I/O (Multi I/O)                          <98...
**W83977ATF       WINBOND I/O (Multi I/O)                          <98...
**
**Disk Controller:
**W83759/A/F/AF   Advanced VL-IDE Disk Controller                  <96...
**W83769          Local Bus IDE Solution                           <94...
**
**UARTS:
**W86C250A  UART (equivalent of INS8C250A) [no datasheet]
**W86C450/P Universal Asynchronous Receiver/Transmitter         <Jul89...
**W86C451   I/O controller for IBM PC/AT/XT                     <Jul89...
**W86C452   I/O controller for IBM PC/AT                         Jul89...
**W86C456   I/O controller [no datasheet]                            ?
**W860551/P UART with FIFO and Printer Port Controller             <94...
**
**Other:...
*ZyMOS...
*General Sources:...

(c) Copyright mR_Slugs Warehouse - All rights Reserved