[Home] [This version is outdated, a new version is here]
*Title...
*Search:...
*Read Me/FAQ/General Info...
*_IBM...
*ACC Micro...
*ALD...
*ALi...
*AMD . . . . . . . [no datasheets, some info]...
*Chips & Technologies...
*Contaq  . . . . . [no datasheets, some info]...
*Efar Microsystems [no datasheets, some info]...
*ETEQ...
*Faraday...
*Forex . . . . . . [List only, no datasheets found]...
*Intel...
**?????  (Profusion)    c:99
Chips:         
Memory Access Controller (MAC)  
Data Interface Buffer (DIB)
CPUs:          8x P-III Xeon Oct
DRAM Types:    SDRAM PC100 2-way Interleave dual channel
Max Mem:       32GB
ECC/Parity:    ECC
AGP speed:     N/A
Bus Speed:     100
PCI Clock/Bus: 1/3 PCI-66/64



**800 series...
*Headland/G2...
*HMC (Hulon Microelectronics)...
*Logicstar...
*Motorola...
*OPTi...
*PC CHIPS/Amptron/Atrend/ECS/Elpina/etc...
*SIS...
*Symphony...
*TI (Texas Instruments)...
*UMC...
**Other chips:
***Video:...
***Disk:...
***Peripheral:...
***Other:
UM3750A         Programmable 12-bit Encoder/Decoder
UM6502/07/12    8-bit Microprocessor 1,2,3,4 MHz Versions
UM6502E         8-bit Microprocessor 1,2,3,4 MHz Versions
UM8048/35/49/39 Microcontroller
UM8051/31       Microcontroller
UM74HCT590      8 bit Binary Counter with Output Registers
UM74HCT646      Octal Bus Transceiver and Register

UM2332/UM2333/UM2364  Mask ROM 
UM2366/A              Mask ROM
UM23128/A             Mask ROM
UM23256/A             Mask ROM
UM2147/UM2148/UM2149  SRAM
UM6104/UM6104-1       SRAM
UM6114/UM6116-2/-3/-4 SRAM
UM6116-5/UM6164       SRAM
UM6167/UM6168         SRAM

UM9001/UM9003AF Network?
UM9007F/UM9008  Network?
UM9009          Network?
UM9017F/UM9018  Ethernet
UM9026          Fast Ethernet
UM9090          Network?


*Unresearched:...
*VIA...
*VLSI...
*Western Digital...
**WD76C30x   Perip. Ctrl, Interrupt Multiplex, and Clock Gen <11/18/91
***Notes:...
***Info:
GENERAL
The WD76C30/LV device provides three  functional groups.  It is a Per-
ipheral Controller, Interrupt Multiplexer, and Clock Generator.

The  low power  CMOS  WD76C30/LV  is a  single  device solution  which
provides  interrupt multiplexing logic,  clock generation,  two serial
ports, and one bidirectional parallel port.

Interrupt  multiplexing logic interfaces  the PC/AT  interrupt request
lines with the WD76C10 Single Chip AT Controller.

Integrated clock generation circuitry uses  the 48 MHz input signal to
generate the 1.8462, 3.072, and 8.0 MHz clocks used internally for the
two serial  ports, a 9.6 MHz  Signal used for  the keyboard controller
and  floppy controller,  a programmable  duty/frequency clock  for the
80287 coprocessor, and  a 16 MHz clock for  driving the WD76C10 Single
Chip AT Controller, and floppy controller.

For low power implementations  such as laptops, oscillator disable and
sleep modes are available to power down unused logic.

The bidirectional  parallel port is software configurable  as either a
PC/AT or a PS/2 compatible port. The parallel port data lines and open
drain printer signals have high current drive capabilities.

Each ACE is  programmable as either a WD16C550  or WD16C450 compatible
device. Each WD16C550 configured ACE  is capable of buffering up to 16
bytes  of  data  upon   reception,  relieving  the  CPU  of  interrupt
overhead.  Buffering  of data  also  allows  greater  latency time  in
interrupt servicing which is vital in a multitasking environment. Each
ACE has a maximum recommended data rate of 512 Kbaud.

WD76C30/LV DIFFERENCES
Both the  WD76C30 and WD76C30LV  operate with two power  supplies. The
WD76C30 logic  is powered  by a 5.0  volt supply, while  the WD76C30LV
logic is powered  by a 3.3 volt supply.  The  parallel and serial port
interfaces are only supported by the WD76C30.

PERIPHERAL CONTROLLER
The peripheral controller is  functionally equivalent to the WD16C452/
552. The  mode of operation of  the serial ports and  parallel port is
selectable  via  the  Mode  Select  Register.   Each  serial  port  is
configurable as either a FIFO  enhanced ACE (WD16C550 compatible) or a
standard ACE (WD16C450). The parallel port is configurable as either a
PS/2 bidirectional parallel port  or a PC/AT compatible parallel port.
A detailed description of the  Mode Selection Register is described in
the parallel port section.

***Versions:...
***Features:...
**WD7615     Desktop Buffer Manager                          <04/15/92...
**WD7625     Desktop Buffer Manager                          <10/01/92...
**WD8120LV   Super I/O [no datasheet]                                ?
**Other Chips:...
*Winbond...
*ZyMOS...
*General Sources:...