[Home] [This version is outdated, a new version is here]
*Title...
*Search:...
*Read Me/FAQ/General Info...
*_IBM...
*ACC Micro...
*ALD...
*ALi...
*AMD . . . . . . . [no datasheets, some info]...
*Chips & Technologies...
*Contaq . . . . . [no datasheets, some info]...
*Efar Microsystems [no datasheets, some info]...
*ETEQ...
*Faraday...
*Forex . . . . . . [List only, no datasheets found]...
*Intel...
**82495XP/490XP Cache Controller / Cache RAM (for i860) 06/05/91
***Notes:...
***Info:...
***Features:...
**82496/491 Cache Controller / Cache RAM (for P5 Pentium) 03/22/93...
**82497/492 Cache Controller / Cache RAM (for P54 Pentium) <Nov94...
**82498/493 Cache Controller / Cache RAM (for P54 Pentium) <Nov94...
**
**Later chipsets (basic spec):
**440 series:...
**450NX (?) 06/29/98:...
**????? (Profusion) c:99...
**800 series...
*Headland/G2...
*HMC (Hulon Microelectronics)...
*Logicstar...
*Motorola...
*OPTi...
*PC CHIPS/Amptron/Atrend/ECS/Elpina/etc...
*SIS...
*Symphony...
**SL82C465 Cache Controller (for 486/386DX/SX) c:91
***Info:
The SL82C465 cache controller supports both 1X and 2X clock modes. The
1X clock mode means that the CCLK2 signal is used as the CPU clock;
the 2X clock mode means that the PCLK signal (half the frequency and
the phase indicator of CCLK2) is used as the CPU clock. The SL82C465
and other CPU local bus devices run at the same clock frequency as the
CPU, while the rest of the system runs at the frequency of PCLK. In
other words, the operating frequency of the system logic is either the
same (2X clock mode) or half the speed of the CPU (1X clock mode). For
the 1X clock mode, the timing of the signals between the CPU/Cache and
the system logic interface is converted by the SL82C465 automatically
to satisfy the requirement of individual clocks. Table 1-1 [see
datasheet] lists the operating frequencies of the CPU local bus and
the system logic with the oscillator used.
The 2X clock mode is recommended for a CPU frequency no faster than
33Mhz because the system logic is available at the targeted speed and
the performance is slightly better than if 1X clock mode were
used. For a CPU frequency faster than 33Mhz, the 1X clock mode is
preferred for 486 systems because it becomes increasingly more
difficult to build a reliable system with an oscillator faster than
66Mhz.
***Versions:...
***Features:...
*TI (Texas Instruments)...
*UMC...
*Unresearched:...
*VIA...
*VLSI...
*Western Digital...
*Winbond...
**W83977ATF WINBOND I/O (Multi I/O) <98
***Info:...
***Versions:...
***Features:
General
o Plug & Play 1.0A compatible
o Support 13 IRQs, 4 DMA channels, full 16-bit address decoding
o Capable of ISA Bus IRQ Sharing
o Compliant with Microsoft PC97 Hardware Design Guide
o Support DPM (Device Power Management), ACPI
o Report ACPI status interrupt by SCI signal issued from any of the
13 IQRs pins or GPIO xx
o Programmable configuration settings
o Single 24/48 Mhz clock input
FDC
o Compatible with IBM PC AT disk drive systems
o Variable write pre-compensation with track selectable capability
o Support vertical recording format
o DMA enable logic
o 16-byte data FIFOs
o Support floppy disk drives and tape drives
o Detects all overrun and underrun conditions
o Built-in address mark detection circuit to simplify the read
electronics
o FDD anti-virus functions with software write protect and FDD
write enable signal (write data signal was forced to be inactive)
o Support up to four 3.5-inch or 5.25-inch floppy disk drives
o Completely compatible with industry standard 82077
o 360K/720K/1.2M/1.44M/2.88M format; 250K, 300K, 500K, 1M, 2M bps
data transfer rate
o Support 3-mode FDD, and its Win95 driver
UART
o Two high-speed 16550 compatible UARTs with 16-byte send/receive
FIFOs
o MIDI compatible
o Fully programmable serial-interface characteristics:
- 5, 6, 7 or 8-bit characters
- Even, odd or no parity bit generation/detection
- 1, 1.5 or 2 stop bits generation
o Internal diagnostic capabilities:
- Loop-back controls for communications link fault isolation
- Break, parity, overrun, framing error simulation
o Programmable baud generator allows division of 1.8461 Mhz and 24
Mhz by 1 to (2^16-1)
o Maximum baud rate up to 921k bps for 14.769 Mhz and 1.5M bps
for 24 Mhz
Infrared
o Support IrDA version 1.0 SIR protocol with maximum baud rate up to
115.2K bps
o Support SHARP ASK-IR protocol with maximum baud rate up to 57,600
bps
o Support IrDA version 1.1 MIR (1.152M bps) and FIR (4M bps) protocol
- Single DMA channel for transmitter or receiver
- 3rd UART with 32-byte FIFO is supported in both TX/RX transmission
- 8-byte status FIFO is supported to store received frame status
(such as overrun CRC error, etc.)
o Support auto-config SIR and FIR
Parallel Port
o Compatible with IBM parallel port
o Support PS/2 compatible bi-directional parallel port
o Support Enhanced Parallel Port (EPP) - Compatible with IEEE 1284
specification
o Support Extended Capabilities Port (ECP) - Compatible with IEEE
1284 specification
o Extension FDD mode supports disk drive B; and Extension 2FDD mode
supports disk drives A and B through parallel port
o Enhanced printer port back-drive current protection
Keyboard Controller
o 8042 based with optional F/W from AMIKKEY-2, Phoenix MultiKey/42
or customer code with 2K bytes of programmable ROM, and 256 bytes
of RAM
o Asynchronous Access to Two Data Registers and One status Register
o Software compatibility with the 8042 and PC87911 microcontrollers
o Support PS/2 mouse
o Support port 92
o Support both interrupt and polling modes
o Fast Gate A20 and Hardware Keyboard Reset
o 8 Bit Timer/ Counter
o Support binary and BCD arithmetic
o 6MHz, 8 MHz, 12 MHz, or 16 MHz operating frequency
General Purpose I/O Ports
o 23 programmable general purpose I/O ports; 1 dedicate, 22 optional
o General purpose I/O ports can serve as simple I/O ports, interrupt
steering inputs, watching dog timer output, power LED output,
infrared I/O pins, general purpose address decoder, KBC control
I/O pins
OnNow Funtions
o Keyboard wake-up by programmable keys (patent pending)
o Mouse wake-up by programmable buttons (patent pending)
o CIR wake-up by programmable keys (patent pending)
Package
o 128-pin PQFP
**
**Disk Controller:
**W83759/A/F/AF Advanced VL-IDE Disk Controller <96...
**W83769 Local Bus IDE Solution <94...
**
**UARTS:
**W86C250A UART (equivalent of INS8C250A) [no datasheet]
**W86C450/P Universal Asynchronous Receiver/Transmitter <Jul89...
**W86C451 I/O controller for IBM PC/AT/XT <Jul89...
**W86C452 I/O controller for IBM PC/AT Jul89...
**W86C456 I/O controller [no datasheet] ?
**W860551/P UART with FIFO and Printer Port Controller <94...
**
**Other:...
*ZyMOS...
*General Sources:...
(c) Copyright mR_Slugs Warehouse - All rights Reserved