[Home] [This version is outdated, a new version is here]
*Title...
*Search:...
*Read Me/FAQ/General Info...
*_IBM...
*ACC Micro...
*ALD...
*ALi...
*AMD . . . . . . . [no datasheets, some info]...
*Chips & Technologies...
*Contaq . . . . . [no datasheets, some info]...
*Efar Microsystems [no datasheets, some info]...
*ETEQ...
*Faraday...
*Forex . . . . . . [List only, no datasheets found]...
*Intel...
**82495XP/490XP Cache Controller / Cache RAM (for i860) 06/05/91
***Notes:...
***Info:...
***Features:...
**82496/491 Cache Controller / Cache RAM (for P5 Pentium) 03/22/93...
**82497/492 Cache Controller / Cache RAM (for P54 Pentium) <Nov94...
**82498/493 Cache Controller / Cache RAM (for P54 Pentium) <Nov94...
**
**Later chipsets (basic spec):
**440 series:...
**450NX (?) 06/29/98:...
**????? (Profusion) c:99...
**800 series...
*Headland/G2...
*HMC (Hulon Microelectronics)...
*Logicstar...
*Motorola...
*OPTi...
**82C496/7 DXBB PC/AT Chipset (Cached) <01/16/92
***Info:
The OPTi 82C497 is a Direct Mapped Write Back cache controller with
one level write buffer that is an optional part of the DXBB (Building
Block) Chip set. The DXBB also contains the 82C496 and the 82C206,
which form the heart of the system. The 82C497 is added to the DXBB
chip set for cache based systems.
The OPTi 82C496 offers an upgradable CPU module base-board solution
for the 80386 or the 80486 PC/AT system. By swapping the CPU module,
the vendor can configure the 82C496 driven base-board into various
32-bit AT systems - 386 or 486 CPU, with cache or without cache and
rated at 16MHz- 50MHz.
For the Non-Cache systems, the CPU interfaces directly with the 82C496
and the local devices, like the local VGA controller or the local hard
disk adaptor.
For cache based systems the 82C497 (the cache controller) sits between
the CPU and the 82C496 and the local devices. All the high frequency
signals are isolated by the 82C497. This allows the base-board to run
at a fixed speed (25 or 33MHz) - while the CPU and the Cache can run
synchronously at any determined rated speed. This provides a reliable
upgrade method for the CPU modules.
***Configurations:...
***Features:...
**82C498 DXWB PC/AT chipset [no datasheet] ?...
**82C499 DXSC DX System Controller c:93...
**82C546/547 Python PTM3V c:94...
**82C556/7/8 Viper [no datasheet] ?...
**82C556/7/8N Viper-N Viper Notebook Chipset <05/25/95...
**82C556M/7M/8E Viper-N+ Viper Notebook Chipset c:96...
**82C566/7/8 Viper-Max Chipset Scalable MultiMedia PC Solution ?...
**82C571/572 486/Pentium c:93...
**82C576/7/8 Viper Xpress [no datasheet] ?...
**82C576/8/9 Viper XPress+ [no datasheet, some info] <01/16/97...
**82C596/597 PTMAWB Pentium Adaptive Write-back (Cobra) c:93...
**82C650/1/2 Discovery (Pentium Pro) [no datasheet] ?...
**82C681/2/6/7 386/486WB EISA c:92...
**82C683 386/486AWB EISA [no datasheet] ?...
**82C693/6/7 Pentium uP Write Back Cache EISA c:93...
**82C700 FireStar c:97...
**82C701 FireStar Plus c:97...
**82C750 Vendetta [no datasheet] ?...
**82c801 SCWB2 DX Single Chip Solution c:92...
**82C802 SCWB2 PC/AT Single Chip [no datasheet] ?...
**82C802G/GP System/Power Management Controller (cached) c:93...
**82C895 System/Power Management Controller (cached) c:Sep94...
**82C898 System/Power Management Controller (non-cache)c:Nov94...
**
**Support Chips:
**82C601/2 Buffer Devices <Nov94...
**82C822 PCIB (VLB-to-PCI bridge) c:94...
**Other:...
*PC CHIPS/Amptron/Atrend/ECS/Elpina/etc...
*SIS...
*Symphony...
*TI (Texas Instruments)...
*UMC...
*Unresearched:...
*VIA...
*VLSI...
*Western Digital...
*Winbond...
**W83977ATF WINBOND I/O (Multi I/O) <98
***Info:...
***Versions:...
***Features:
General
o Plug & Play 1.0A compatible
o Support 13 IRQs, 4 DMA channels, full 16-bit address decoding
o Capable of ISA Bus IRQ Sharing
o Compliant with Microsoft PC97 Hardware Design Guide
o Support DPM (Device Power Management), ACPI
o Report ACPI status interrupt by SCI signal issued from any of the
13 IQRs pins or GPIO xx
o Programmable configuration settings
o Single 24/48 Mhz clock input
FDC
o Compatible with IBM PC AT disk drive systems
o Variable write pre-compensation with track selectable capability
o Support vertical recording format
o DMA enable logic
o 16-byte data FIFOs
o Support floppy disk drives and tape drives
o Detects all overrun and underrun conditions
o Built-in address mark detection circuit to simplify the read
electronics
o FDD anti-virus functions with software write protect and FDD
write enable signal (write data signal was forced to be inactive)
o Support up to four 3.5-inch or 5.25-inch floppy disk drives
o Completely compatible with industry standard 82077
o 360K/720K/1.2M/1.44M/2.88M format; 250K, 300K, 500K, 1M, 2M bps
data transfer rate
o Support 3-mode FDD, and its Win95 driver
UART
o Two high-speed 16550 compatible UARTs with 16-byte send/receive
FIFOs
o MIDI compatible
o Fully programmable serial-interface characteristics:
- 5, 6, 7 or 8-bit characters
- Even, odd or no parity bit generation/detection
- 1, 1.5 or 2 stop bits generation
o Internal diagnostic capabilities:
- Loop-back controls for communications link fault isolation
- Break, parity, overrun, framing error simulation
o Programmable baud generator allows division of 1.8461 Mhz and 24
Mhz by 1 to (2^16-1)
o Maximum baud rate up to 921k bps for 14.769 Mhz and 1.5M bps
for 24 Mhz
Infrared
o Support IrDA version 1.0 SIR protocol with maximum baud rate up to
115.2K bps
o Support SHARP ASK-IR protocol with maximum baud rate up to 57,600
bps
o Support IrDA version 1.1 MIR (1.152M bps) and FIR (4M bps) protocol
- Single DMA channel for transmitter or receiver
- 3rd UART with 32-byte FIFO is supported in both TX/RX transmission
- 8-byte status FIFO is supported to store received frame status
(such as overrun CRC error, etc.)
o Support auto-config SIR and FIR
Parallel Port
o Compatible with IBM parallel port
o Support PS/2 compatible bi-directional parallel port
o Support Enhanced Parallel Port (EPP) - Compatible with IEEE 1284
specification
o Support Extended Capabilities Port (ECP) - Compatible with IEEE
1284 specification
o Extension FDD mode supports disk drive B; and Extension 2FDD mode
supports disk drives A and B through parallel port
o Enhanced printer port back-drive current protection
Keyboard Controller
o 8042 based with optional F/W from AMIKKEY-2, Phoenix MultiKey/42
or customer code with 2K bytes of programmable ROM, and 256 bytes
of RAM
o Asynchronous Access to Two Data Registers and One status Register
o Software compatibility with the 8042 and PC87911 microcontrollers
o Support PS/2 mouse
o Support port 92
o Support both interrupt and polling modes
o Fast Gate A20 and Hardware Keyboard Reset
o 8 Bit Timer/ Counter
o Support binary and BCD arithmetic
o 6MHz, 8 MHz, 12 MHz, or 16 MHz operating frequency
General Purpose I/O Ports
o 23 programmable general purpose I/O ports; 1 dedicate, 22 optional
o General purpose I/O ports can serve as simple I/O ports, interrupt
steering inputs, watching dog timer output, power LED output,
infrared I/O pins, general purpose address decoder, KBC control
I/O pins
OnNow Funtions
o Keyboard wake-up by programmable keys (patent pending)
o Mouse wake-up by programmable buttons (patent pending)
o CIR wake-up by programmable keys (patent pending)
Package
o 128-pin PQFP
**
**Disk Controller:
**W83759/A/F/AF Advanced VL-IDE Disk Controller <96...
**W83769 Local Bus IDE Solution <94...
**
**UARTS:
**W86C250A UART (equivalent of INS8C250A) [no datasheet]
**W86C450/P Universal Asynchronous Receiver/Transmitter <Jul89...
**W86C451 I/O controller for IBM PC/AT/XT <Jul89...
**W86C452 I/O controller for IBM PC/AT Jul89...
**W86C456 I/O controller [no datasheet] ?
**W860551/P UART with FIFO and Printer Port Controller <94...
**
**Other:...
*ZyMOS...
*General Sources:...
(c) Copyright mR_Slugs Warehouse - All rights Reserved