[Home] [This version is outdated, a new version is here]
*Title...
*Search:...
*Read Me/FAQ/General Info...
*_IBM...
*ACC Micro...
*ALD...
*ALi...
*AMD . . . . . . . [no datasheets, some info]...
*Chips & Technologies...
*Contaq . . . . . [no datasheets, some info]...
*Efar Microsystems [no datasheets, some info]...
*ETEQ...
*Faraday...
*Forex . . . . . . [List only, no datasheets found]...
*Intel...
**82495XP/490XP Cache Controller / Cache RAM (for i860) 06/05/91
***Notes:...
***Info:...
***Features:...
**82496/491 Cache Controller / Cache RAM (for P5 Pentium) 03/22/93...
**82497/492 Cache Controller / Cache RAM (for P54 Pentium) <Nov94...
**82498/493 Cache Controller / Cache RAM (for P54 Pentium) <Nov94...
**
**Later chipsets (basic spec):
**440 series:...
**450NX (?) 06/29/98:...
**????? (Profusion) c:99...
**800 series...
*Headland/G2...
*HMC (Hulon Microelectronics)...
*Logicstar...
*Motorola...
*OPTi...
**82C701 FireStar Plus c:97
***Notes:...
***Info:
Overview
This section describes the follow-on chip to the OPTi FireStar ACPI
solution, the FireStar Plus. The key features of this new product can
be summarized as follows.
o Mostly backward-compatible in pin function and register set with
FireStar ACPI (some PIO functions have been moved from critical
pins to improve timing)
o Implements ATA-33 (Ultra DMA) IDE Interface, with support for all
modes
o Supports 2.5V CPUs
o Incorporates MA13 support for 64Mb SDRAM chips
o Incorporates 64Mb EDO DRAM support
o Enables use of synchronous DRAM on all six banks (original
FireStar chip limited synchronous DRAM to the first four banks)
o Allows redefinition of many interface pins for better utilization
of chipset PIO features (many new function pins are easily
available)
Features
The following paragraphs describe the feature set changes between
FireStar ACPI and FireStar Plus.
Ultra DMA IDE Interface
The ATA33 specification for synchronous bus mastering IDE, also known
as Ultra DMA, is fully supported by FireStar Plus.
Synchronous DRAM on All Banks
The original FireStar chip supports synchronous DRAM only on RAS0-3#.
FireStar Plus also supports synchronous DRAM on RAS4-5#. The
additional functionality is selected through register bits that are
already defined on the FireStar ACPI part.
2.5V CPU Interface
FireStar Plus supports newer CPUs with I/O voltage requirements as low
as 2.5V. The pin redefinition is as follows.
o Pins E8, G5, T5, and W5 are now VCC_CPU and can be powered at 2.5V
or 3.3V.
o Pins K5, H22, and AB19 are now VCC_CORE and must always be powered
at 3.3V.
o Pin M5, CPUCLKIN, must receive a clock on the VCC_CPU plane. So if
a 2.5V CPU is used, this clock should also be 2.5V.
The 2.5V interface is a strap-selected option. It is selected by a
strap on pin B7 (new MA13 pin). If B7 is sensed low at reset, the CPU
interface is 3.3V; if sensed high along with TMS (pin AB5) low, the
CPU interface is 2.5V.
Redefinition of DRQ/DACK# Interface
The 7 pins assigned to DACK0-7# can be redefined to improve avail-
ability of PIO pins.
While the new definition only involves circuit modifications to the
DACK0-7# pins, the overall gain is much greater when used with the
82C602A Companion Chip in its Viper Note-book Mode A configuration.
o 8 power management inputs are now available, muxed in with the
DRQs and IRQ8# on the four EPMMUX pins.
o 7 full-featured PIO pins are available on the former FireStar
DRQ0-7 pins and IRQ8# pin. The number of pins is actually 8, but
is reduced b y 1 because one must be programmed as ATCLK/2.
o 12 PPWR outputs are generated by latching the SD bus lines from
PCTLH (FireStar PPWRL) and PCTLL (FireStar RSTDRV).
o The ISA bus RSTDRV signal is now generated by the 82C602A chip, so
that the FireStar RSTDRV pin can be used for PPWR generation
(power control latch control signal). If the extra PPWR signals
are not needed, the FireStar RSTDRV pin becomes useful as a full-
featured PIO pin.
Warnings
1. Until the Extended Mode option has been programmed, DACK3-7# will
be driving out against the signal input muxes. It is therefore
important to ensure that the logic will not be harmed by this
arrangement (the FireStar outputs safely accept being driven by
external logic in this mode).
2. EDACKEN is an option used to ensure proper ISA master operation.
It prevents the EDACK decoder from glitching its DACK# outputs during
EDACK switching. If ISA masters are not supported in the system, this
option is not needed (tie the EDACK line high on the 82C602A).
3. There are no provisions to block conflicts in case more than one
pin is programmed to the same function. For example, if a PIO pin is
programmed to be ACPI8-11, and the Extended Mode option also enables
EPMMUX1 to bring in ACPI8-11, the results are unpredictable.
***Configurations:...
***Features:...
**82C750 Vendetta [no datasheet] ?...
**82c801 SCWB2 DX Single Chip Solution c:92...
**82C802 SCWB2 PC/AT Single Chip [no datasheet] ?...
**82C802G/GP System/Power Management Controller (cached) c:93...
**82C895 System/Power Management Controller (cached) c:Sep94...
**82C898 System/Power Management Controller (non-cache)c:Nov94...
**
**Support Chips:
**82C601/2 Buffer Devices <Nov94...
**82C822 PCIB (VLB-to-PCI bridge) c:94...
**Other:...
*PC CHIPS/Amptron/Atrend/ECS/Elpina/etc...
*SIS...
*Symphony...
*TI (Texas Instruments)...
*UMC...
**UM82C480 386/486 PC Chip Set c91
***Info:
The UMC82C480 is a highly integrated, IBM PC/AT compatible chip set
for high performance 80386/80486 based personal computer systems.
Built with exquisite [yes it really says that] cache controller in
advanced 1.0um CMOS technology, UM82C481 (Integrated Memory
Controller, IMC), UM82C482 (Integrated System Controller, ISC), with
UM82C206 (Integrated Peripheral Controller, IPC), and limited counts
of commercial parts constitute a low cost, highly reliable, full
advanced feature personal computer system.
The UM82C482, Integrated System Controller (ISC), is part of UMC's
high performance 80386/80486 PC/AT chip set. It contains AT bus
control logic, data bus conversion logic, CPU reset logic, clock
generation for CPU, keyboard and timer, DMA/refresh logic and
peripheral interface logic. Incorporated with UM82C481, integrated
Memory Controller (IMC), and UM82C206, Integrated Peripheral
Controller (IPC), ISC provides system control functions for overall
PC/AT computer system.
The UM82C481, Integrated Memory Controller (IMC), is part of UMC's
high performance 80386/80486 PC/AT chip set. It contains sophisticated
direct-mapped cache controller with write back operation, and fast
page mode DRAM controller. Incorporated with UM82C482, Integrated
System Controller (ISC), and UM82C206, Integrated Peripheral
Controller (IPC), IMC provides main memory management function for the
PC/AT computer system.
***Configurations:...
***Features:...
**UM82C493/491 ??????????????? [no datasheet] ?...
**UM8498/8496 486 VL Chipset "Super Energy Star Green"[no dsheet]c94...
**UM8881/8886 HB4 PCI Chipset "Super Energy Star Green"[no dsheet]c94...
**UM8890 Pentium chipset [no datasheet] ?...
**
**Support Chips:
**UM82152 Cache Controller (AUStek A38152 clone) <91...
**UM82C852 Multi I/O For XT <91...
**UM82C206 Integrated Peripheral Controller <91...
**UM82c45x Serial/Parallel chips ?...
**Other chips:...
*Unresearched:...
*VIA...
*VLSI...
*Western Digital...
*Winbond...
*ZyMOS...
*General Sources:...
(c) Copyright mR_Slugs Warehouse - All rights Reserved