[Home] [This version is outdated, a new version is here]
*Title...
*Search:...
*Read Me/FAQ/General Info...
*_IBM...
*ACC Micro...
*ALD...
*ALi...
*AMD . . . . . . . [no datasheets, some info]...
*Chips & Technologies...
*Contaq  . . . . . [no datasheets, some info]...
*Efar Microsystems [no datasheets, some info]...
*ETEQ...
*Faraday...
*Forex . . . . . . [List only, no datasheets found]...
*Intel...
**82495XP/490XP Cache Controller / Cache RAM (for i860)       06/05/91
***Notes:...
***Info:...
***Features:...
**82496/491     Cache Controller / Cache RAM (for P5 Pentium) 03/22/93...
**82497/492   Cache Controller / Cache RAM (for P54 Pentium)    <Nov94
***Notes:...
***Info:...
***Configurations:...
***Features:...
**82498/493   Cache Controller / Cache RAM (for P54 Pentium)    <Nov94...
**
**Later chipsets (basic spec):
**440 series:...
**450NX  (?)            06/29/98:...
**?????  (Profusion)    c:99...
**800 series...
*Headland/G2...
*HMC (Hulon Microelectronics)...
*Logicstar...
*Motorola...
*OPTi...
*PC CHIPS/Amptron/Atrend/ECS/Elpina/etc...
*SIS...
*Symphony...
**SL82C465    Cache Controller (for 486/386DX/SX)                 c:91
***Info:
The SL82C465 cache controller supports both 1X and 2X clock modes. The
1X clock  mode means that the CCLK2  signal is used as  the CPU clock;
the 2X clock  mode means that the PCLK signal  (half the frequency and
the phase indicator  of CCLK2) is used as the  CPU clock. The SL82C465
and other CPU local bus devices run at the same clock frequency as the
CPU, while  the rest of the system  runs at the frequency  of PCLK. In
other words, the operating frequency of the system logic is either the
same (2X clock mode) or half the speed of the CPU (1X clock mode). For
the 1X clock mode, the timing of the signals between the CPU/Cache and
the system logic interface  is converted by the SL82C465 automatically
to  satisfy  the requirement  of  individual  clocks.  Table 1-1  [see
datasheet] lists  the operating frequencies  of the CPU local  bus and
the system logic with the oscillator used.

The 2X  clock mode is recommended  for a CPU frequency  no faster than
33Mhz because the system logic  is available at the targeted speed and
the  performance  is  slightly  better  than if  1X  clock  mode  were
used. For  a CPU  frequency faster  than 33Mhz, the  1X clock  mode is
preferred  for  486  systems  because  it  becomes  increasingly  more
difficult to  build a reliable  system with an oscillator  faster than
66Mhz.

***Versions:...
***Features:...
*TI (Texas Instruments)...
*UMC...
*Unresearched:...
*VIA...
*VLSI...
**VL82C591/593     SuperCore 590                                   c94
***Notes:...
***Configurations:...
**VL82C594/596/597 Wildcat                                         c95...
**I/O Chips:
**VL82C106 Combination I/O chip                                      ?...
**VL82C107 SCAMP  Combination I/O chip                               ?...
**VL82C108 TOPCAT Combination I/O chip                               ?...
**VL82C110 Combination I/O chip                                      ?...
**VL82C113 SCAMP  Combination I/O chip                               ?...
**VL82C114 Combination I/O chip                                      ?...
**Video: ...
**Disk:...
**Modems:
VL7C212A CMOS 300/1200 Bit-Per-Second Modem 
VL7C213 CMOS Parallel Bus Modem Controller. 
VL7C214 CMOS Stand-Alone Modem Interface Controller
VL7C215 CMOS High Speed Parallel Bus Modem Controller 
VL7C224A 2400 Bit-Per-Second Analog Modem 
VL7C225 CMOS 2400 Bit-Per-Second Modem Advanced Coprocessor Family 
VL7C235 CMOS 2400 Bit-Per-Second Modem Advanced Coprocessor Family 
VL7C245 CMOS 2400 Bit-Per-Second Modem Advanced Coprocessor Family 
VL7C312 CMOS 300/1200 BPS Modem With Pin Programmable Receiver Gain
VL7C412 CMOS 300/1200 BPS Modem (Single 5-Volt Power Supply)
VL7C413 CMOS High Speed Parallel Bus Modem Controller 
VL7C414 CMOS Stand-Alone Modem Interface Controller 


**Other:...
**Not sure if they actually exist...
*Western Digital...
*Winbond...
*ZyMOS...
*General Sources:...