[Home] [This version is outdated, a new version is here]
*Title...
*Search:...
*Read Me/FAQ/General Info...
*_IBM...
*ACC Micro...
*ALD...
*ALi...
*AMD . . . . . . . [no datasheets, some info]...
*Chips & Technologies...
*Contaq . . . . . [no datasheets, some info]...
*Efar Microsystems [no datasheets, some info]...
*ETEQ...
*Faraday...
*Forex . . . . . . [List only, no datasheets found]...
*Intel...
**????? (Profusion) c:99
Chips:
Memory Access Controller (MAC)
Data Interface Buffer (DIB)
CPUs: 8x P-III Xeon Oct
DRAM Types: SDRAM PC100 2-way Interleave dual channel
Max Mem: 32GB
ECC/Parity: ECC
AGP speed: N/A
Bus Speed: 100
PCI Clock/Bus: 1/3 PCI-66/64
**800 series...
*Headland/G2...
*HMC (Hulon Microelectronics)...
*Logicstar...
*Motorola...
*OPTi...
**82C898 System/Power Management Controller (non-cache)c:Nov94
***Notes:...
***Info:
Overview
The 82C898 provides a highly integrated solution for fully compatible,
high performance PC/AT platforms. The 82C898 supports 486SX/DX/DX2/DX4
and P24T microprocessors in the most cost effective and power
efficient designs available today. For high-end system applications,
this device offers optimum performance for systems running up to
50MHz.
Based fundamentally on OPTi’s proven 82C801 and 82C802 design
architectures, the 82C898 adds additional memory configurations and
extensive power management control for the processor and other
motherboard components.
The 82C898 supports the latest in write-back processor designs from
Intel, AMD, and Cyrix, as well as supporting the AT bus and VESA local
bus for compatibility and performance. It also includes an 82C206
Integrated Peripherals Controller (IPC), all in a single 208-pin PQFP
(Plastic Quad Flat Pack) for low cost.
Power Management
Figure 2-1 [see datasheet] exemplifies the flexibility of an
82C898/82C602-based designs GREEN strategy. System designs can easily
accommodate both SLe and non-SLe CPUs. If an Intel non-SLe CPU is
used, SMI#, SMIAOT#, and FLUSH# are no connects. One design can easily
accommodate both types of processors with minimal changes for
upgrades.
***Configurations:...
***Features:...
**
**Support Chips:
**82C601/2 Buffer Devices <Nov94...
**82C822 PCIB (VLB-to-PCI bridge) c:94...
**Other:...
*PC CHIPS/Amptron/Atrend/ECS/Elpina/etc...
*SIS...
*Symphony...
*TI (Texas Instruments)...
*UMC...
*Unresearched:...
*VIA...
*VLSI...
*Western Digital...
*Winbond...
**W83877F WINBOND I/O (Multi I/O) <96
***Info:...
***Versions:...
***Features:
FDC:
o Compatible with IBM PC AT disk drive systems
o Variable write pre-compensation with track selectable capability
o DMA enable logic
o Non-burst mode DMA option
o Supports floppy disk drives and tape drives
o Detects all overrun and underrun conditions
o Data rate and drive control registers
o Built-in address mark detection circuit to simplify the read
electronics
o IBM PC system address decoder
o Supports up to two embedded hard disk drives (IDE AT BUS)
o Single 24 MHz crystal input
o FDD anti-virus functions with software write protect and FDD write
enable signal, write data signal force inactive
o Supports up to four 3.5-inch or 5.25-inch floppy disk drives
o Completely compatible with industry standard 82077
o 360K/720K/1.2M/1.44M/2.88M format
o 250K, 300K, 500K, 1M bps data transfer rate
o Supports vertical recording format
o 16-byte data FIFOs
UART:
o Two high-speed 16550 compatible UARTs with 16-byte send/receive
FIFOs
o MIDI compatible
o Fully programmable serial-interface characteristics:
- 5, 6, 7 or 8-bit characters
- Even, odd or no parity bit generation/detection
- 1, 1.5 or 2 stop bits generation
o Internal diagnostic capabilities:
- Loop-back controls for communications link fault isolation
- Break, parity, overrun, framing error simulation
o Programmable baud generator allows division of 1.8461 MHz and 24
MHz by 1 to (2^16-1)
Parallel Port:
o Compatible with IBM parallel port
o Supports parallel port with bidirectional lines
o Supports Enhanced Parallel Port (EPP)
- Compatible with IEEE 1284 specification
o Supports Extended Capabilities Port (ECP)
- Compatible with IEEE 1284 specification
o Extension FDD mode supports disk drive B through parallel port
o Extension Adapter Mode supports pocket devices through parallel port
o Extension 2FDD mode supports disk drives A and B through parallel
port
o JOYSTICK mode supports joystick through parallel port
Others:
o Programmable configuration settings
o Immediate or automatic power-down mode for power management
o All hardware power-on settings have internal pull-up or pull-down
resistors as default value
o Packaged in 100-pin QFP
o Configurable Plug and Play registers
o Infrared communication port
**W83877TF/TG/TD WINBOND I/O (Multi I/O) c97...
**W83977F/G/AF/AG WINBOND I/O (Multi I/O) c97...
**W83977TF WINBOND I/O (Multi I/O) c97...
**W83977EF WINBOND I/O (Multi I/O) <98...
**W83977ATF WINBOND I/O (Multi I/O) <98...
**
**Disk Controller:
**W83759/A/F/AF Advanced VL-IDE Disk Controller <96...
**W83769 Local Bus IDE Solution <94...
**
**UARTS:
**W86C250A UART (equivalent of INS8C250A) [no datasheet]
**W86C450/P Universal Asynchronous Receiver/Transmitter <Jul89...
**W86C451 I/O controller for IBM PC/AT/XT <Jul89...
**W86C452 I/O controller for IBM PC/AT Jul89...
**W86C456 I/O controller [no datasheet] ?
**W860551/P UART with FIFO and Printer Port Controller <94...
**
**Other:...
*ZyMOS...
*General Sources:...
(c) Copyright mR_Slugs Warehouse - All rights Reserved