[Home] [This version is outdated, a new version is here]
*Title...
*Search:...
*Read Me/FAQ/General Info...
*_IBM...
*ACC Micro...
*ALD...
*ALi...
*AMD . . . . . . . [no datasheets, some info]...
*Chips & Technologies...
*Contaq  . . . . . [no datasheets, some info]...
*Efar Microsystems [no datasheets, some info]...
*ETEQ...
*Faraday...
*Forex . . . . . . [List only, no datasheets found]...
*Intel...
**82495XP/490XP Cache Controller / Cache RAM (for i860)       06/05/91
***Notes:...
***Info:...
***Features:...
**82496/491     Cache Controller / Cache RAM (for P5 Pentium) 03/22/93...
**82497/492   Cache Controller / Cache RAM (for P54 Pentium)    <Nov94...
**82498/493   Cache Controller / Cache RAM (for P54 Pentium)    <Nov94...
**
**Later chipsets (basic spec):
**440 series:...
**450NX  (?)            06/29/98:...
**?????  (Profusion)    c:99...
**800 series...
*Headland/G2...
*HMC (Hulon Microelectronics)...
*Logicstar...
*Motorola...
*OPTi...
**82C895         System/Power Management Controller (cached)   c:Sep94
***Notes:...
***Info:...
***Configurations:...
***Features:
o   Processor interface:
    - Intel 80486SX, DX, DX2, SLe, DX4, P24T, P24D 
    - AMD 486DX, DX2, DXL, DXL2, Plus
    - Cyrix DX, DX2, M7
    - CPU frequencies supported 20, 25, 33, 40 and 50MHz
o   Cache interface:
    - Direct Mapped Cache
    - Two banks interleaved or single bank non-interleaved
    - 64, 128, 256 and 512K cache sizes
    - Programmable wait states for L2 cache reads and writes
    - 2-1-1-1 read burst and zero wait state write @ 33MHz
    - No Valid bit required
    - Supports CPUs with L1 write-back support
o   DRAM interface:
    - Up to 128MB main memory support
    - Supports 256KB, 1MB, 4MB, and 16MB single- and double-sided SIMM 
      modules
    - Read page-hit timing of 3-2-2-2 at 33MHz
    - Supports hidden, slow and CAS-before-RAS refresh
    - Four RAS lines to support four banks of DRAM
    - Programmable wait states for DRAM reads and writes
    - Enhanced DRAM configuration map
o   Power management:
    - Support for SMM (System Management Mode) for system power 
      management implementations
    - Programmable power management
    - Programmable wake-up events through hardware, software and 
      external SMI source
    - Multiple level GREEN support (NESTED_GREEN)
    - STPCLK# protocol support
    - One programmable GREEN event timer
o   ISA interface:
    - 100% IBM PC/AT ISA compatible
    - Integrates DMA, timer and interrupt controllers
    - Optional PS/2 style IRQ1 and 12 latching
o   VESA VL interface:
    - Conforms to the VESA v2.0 specification
    - Optional support for up to two VL masters
o   Miscellaneous features:
    - Full support for shadow RAM, write protection, L1/L2 
      cacheability for video, adapter and system BIOS
    - Enhanced arbitration scheme
    - Transparent 8042 emulation for fast CPU reset and GATEA20 
      generation
o   Packaging:
    - Higher integration
    - Reduced TTL count
    - Low-power, high-speed 0.8-micron CMOS technology
    - 208-pin PQFP (Plastic Quad Flat Pack)

**82C898         System/Power Management Controller (non-cache)c:Nov94...
**
**Support Chips:
**82C601/2       Buffer Devices                                 <Nov94...
**82C822         PCIB (VLB-to-PCI bridge)                         c:94...
**Other:...
*PC CHIPS/Amptron/Atrend/ECS/Elpina/etc...
*SIS...
*Symphony...
*TI (Texas Instruments)...
*UMC...
*Unresearched:...
*VIA...
*VLSI...
*Western Digital...
**WD76C30x   Perip. Ctrl, Interrupt Multiplex, and Clock Gen <11/18/91
***Notes:...
***Info:...
***Versions:...
***Features:
o   Two fully programmable and independent serial I/O ports 
    configurable as PC/AT compatible (WD16C452) or PS/2 
    compatible (WD16C552)
    - Loopback controls for communications link fault isolation for 
      each ACE
    - Line break generation and detection for each ACE
    - Complete status reporting capabilities
    - Generation and stripping of serial asynchronous data control 
      bits (start, stop, parity)
    - Programmable baud rate generator and MODEM control signals for 
      each port
    - Programmable baud rate generator input clock
    - Optional 16 byte FIFO buffers on both transmit and receive of 
      each port for CPU relief during high speed data transfer
    - Programmable FIFO threshold levels of 1 , 4, 8, or 14 bytes on 
      each port
o   Parallel port configurable as a fully Centronics or PS/2 
    compatible, bidirectional parallel port
o   Independently programmable parallel port
o   Interrupt multiplexing logic
    - Selectable multiplexing logic for connecting PC/AT interrupt 
      request lines to the WD76C10 single chip AT controller
o   Clock generation circuitry
    - 80287 coprocessor clock generation
    - WD76C10 and floppy controller clock generation
    - 8042 keyboard clock generation
o   Built-in testability features
o   Hardware or software controllable sleep mode
o   CMOS implementation for high speed and low power requirements 
o   Pulse extension on IRQ inputs
o   84-pin PLCC and PQFP packages

**WD7615     Desktop Buffer Manager                          <04/15/92...
**WD7625     Desktop Buffer Manager                          <10/01/92...
**WD8120LV   Super I/O [no datasheet]                                ?
**Other Chips:...
*Winbond...
*ZyMOS...
*General Sources:...