[Home] [This version is outdated, a new version is here]
*Title...
*Search:...
*Read Me/FAQ/General Info...
*_IBM...
*ACC Micro...
*ALD...
*ALi...
*AMD . . . . . . . [no datasheets, some info]...
*Chips & Technologies...
*Contaq . . . . . [no datasheets, some info]...
*Efar Microsystems [no datasheets, some info]...
*ETEQ...
*Faraday...
*Forex . . . . . . [List only, no datasheets found]...
*Intel...
**82495XP/490XP Cache Controller / Cache RAM (for i860) 06/05/91
***Notes:...
***Info:...
***Features:...
**82496/491 Cache Controller / Cache RAM (for P5 Pentium) 03/22/93...
**82497/492 Cache Controller / Cache RAM (for P54 Pentium) <Nov94...
**82498/493 Cache Controller / Cache RAM (for P54 Pentium) <Nov94...
**
**Later chipsets (basic spec):
**440 series:...
**450NX (?) 06/29/98:...
**????? (Profusion) c:99...
**800 series...
*Headland/G2...
*HMC (Hulon Microelectronics)...
*Logicstar...
**SL6012 Memory Mapper for PC-AT (74LS612 compatible) <Jul87
***Info:
The SL6012 Memory Mapper is intended for use in PC-AT design. It can
expand an address bus by 4 bits. In PC-AT applications, 4 bits of the
source address are used to select 1 of 16, eight bit map
registers. These registers are normally programmed (through software)
with the starting address of each memory page. The register data is
output directly for use as the most significant bits of the expanded
address bus. The 8 bits from the SL6012 are used along with the unused
source address bits to form the expanded address bus.
As shown in Table 1 [see datasheet], the SL6012 has three modes of
operation; read, write and map. Data may be written into, or read from
the Memory Mapper when chip select CSN is low. The register select
inputs (RS0 through RS3) select one of the sixteen map registers. When
RWN is low, data is written into a register from the data bus. When
RWN is high data is output from a Memory Mapper register to the data
bus.
The map mode of operation is selected when chip select CSN is high. In
this mode, the register data selected by the map address inputs (MA0
through MA3) will be available on the map outputs (MO0 through
MO7). Note that the map registers are addressed by either the RS
inputs or the MA inputs depending upon the operating mode. When MEN
(Map Enable) is low the map outputs (MO0-MO7) are active. When MEN is
high, the map outputs are at high impedance.
***Versions:...
***Features:...
**SL9010 System Controller (80286/80386SX/DX, 16/20/25MHz) <oct88...
**SL9020 Data Controller <oct88...
**SL9025 Address Controller <oct88...
**SL9090 Universal PC/AT Clock Chip <oct88...
**SL9250 Page Mode Memory Controller (16/20MHz 8MB Max) <oct88...
**SL9350 Page Mode Memory Controller (16/20/25MHz 16MB Max) <oct88...
**Other:...
*Motorola...
*OPTi...
*PC CHIPS/Amptron/Atrend/ECS/Elpina/etc...
*SIS...
*Symphony...
*TI (Texas Instruments)...
*UMC...
*Unresearched:...
*VIA...
*VLSI...
**VL82C312 SCAMP Power Management Unit (PMU) ?
***Info;...
***Versions:...
***Features:
o Provides system activity monitoring, peripheral control, power
supply control, mode timers, and general purpose I/O for
laptop/notebook power management
o Five operation modes:
- On Mode
- Doze Mode
- Sleep Mode
- Suspend Mode
- Off Mode
o Independent programmable timers for power saving modes
o independent programmable timers for LCD and backlight control
o Ten individual power control outputs
- Three for LCD power
- Seven general purpose for peripherals
o Four "low battery" warning monitors: two standard and two
optional
o Multiple power-on sources from Suspend/Off Mode:
- Pushbutton
- RTC alarm
- Modem ring
o AC power monitoring to disable PMU function
o Refresh support in suspend Mode
o Leakage control of outputs during Suspend Mode
o wide range of LCD panel power-up/down sequencing
o Ten general purpose I/O ports; eight with additional i/O
features:
- one programmable blinking I/O
- Two optional low battery inputs
- three inputs AND/OR selectable I/O with one common GPIO output
o Watchdog timer to turn off system power if low battery NMI is
not serviced
o Programmable NMI generation on:
- PMU power mode
- Low battery warning
- External input
- LCD panel timer
- Reschedule Suspend Mode NMI by BIOS
o Controls SCAMP's SLEEP pin
o RTC alarm IRQ output pin for SCAMP
o Additional logic included to minimize system board component
count
o Provides chip selects for:
- IDE interface
- Floppy disk controller
- VL16C452 serial/parallel I/O chip
o Provides multiplexed address/data bus for VGA controller
o Chip ID and revision register
o 144-pin MQFP low-power CMOS IC
**VL82C315A SCAMP II, Low-Power Notebook Chipset ?...
**VL82C322A SCAMP II, Power Management Unit (PMU) ?...
**VL82C316 SCAMP II, PC/AT-Compatible System Controller ?...
**VL82C323 SCAMP II, 5 Volt Power Management Unit (PMU) ?...
**VL82C380 Single chip 386DX PC/AT Controller +on-chip cache ?...
**VL82C325 VL82C386SX System Cache controller ?...
**VL82C335 VL82C386DX System Cache ctrl. [no d.sheet] ?...
**VL82C315A/322A/3216 Kodiak 32-Bit Low-Voltage Chip Set ?...
**VL82C420/144/146 SCAMP IV [no datasheet, some info] c93...
**VL82C480 System/Cache/ISA bus Controller ?...
**VL82C481 System/Cache/ISA bus Controller c92...
**VL82C486 Single-Chip 486, SC486, Controller ?...
**VL82C425 486 Cache controller ?...
**???????? Cheetah 486, PCI [no datasheet] ?...
**VL82C3216 Bus Expanding Controller Cache with write buffer ?...
**VL82C521/522 Lynx/M ?...
**VL82C530 Eagle Ð c95...
**VL82C541/543 Lynx c95...
**VL82C591/593 SuperCore 590 c94...
**VL82C594/596/597 Wildcat c95...
**I/O Chips:
**VL82C106 Combination I/O chip ?...
**VL82C107 SCAMP Combination I/O chip ?...
**VL82C108 TOPCAT Combination I/O chip ?...
**VL82C110 Combination I/O chip ?...
**VL82C113 SCAMP Combination I/O chip ?...
**VL82C114 Combination I/O chip ?...
**Video: ...
**Disk:...
**Modems:...
**Other:...
**Not sure if they actually exist...
*Western Digital...
*Winbond...
*ZyMOS...
*General Sources:...
(c) Copyright mR_Slugs Warehouse - All rights Reserved