[Home] [This version is outdated, a new version is here]
*Title...
*Search:...
*Read Me/FAQ/General Info...
*_IBM...
*ACC Micro...
*ALD...
*ALi...
*AMD . . . . . . . [no datasheets, some info]...
*Chips & Technologies...
*Contaq . . . . . [no datasheets, some info]...
*Efar Microsystems [no datasheets, some info]...
*ETEQ...
*Faraday...
*Forex . . . . . . [List only, no datasheets found]...
*Intel...
**82495XP/490XP Cache Controller / Cache RAM (for i860) 06/05/91
***Notes:...
***Info:...
***Features:...
**82496/491 Cache Controller / Cache RAM (for P5 Pentium) 03/22/93...
**82497/492 Cache Controller / Cache RAM (for P54 Pentium) <Nov94...
**82498/493 Cache Controller / Cache RAM (for P54 Pentium) <Nov94...
**
**Later chipsets (basic spec):
**440 series:...
**450NX (?) 06/29/98:...
**????? (Profusion) c:99...
**800 series...
*Headland/G2...
*HMC (Hulon Microelectronics)...
*Logicstar...
**SL6012 Memory Mapper for PC-AT (74LS612 compatible) <Jul87
***Info:
The SL6012 Memory Mapper is intended for use in PC-AT design. It can
expand an address bus by 4 bits. In PC-AT applications, 4 bits of the
source address are used to select 1 of 16, eight bit map
registers. These registers are normally programmed (through software)
with the starting address of each memory page. The register data is
output directly for use as the most significant bits of the expanded
address bus. The 8 bits from the SL6012 are used along with the unused
source address bits to form the expanded address bus.
As shown in Table 1 [see datasheet], the SL6012 has three modes of
operation; read, write and map. Data may be written into, or read from
the Memory Mapper when chip select CSN is low. The register select
inputs (RS0 through RS3) select one of the sixteen map registers. When
RWN is low, data is written into a register from the data bus. When
RWN is high data is output from a Memory Mapper register to the data
bus.
The map mode of operation is selected when chip select CSN is high. In
this mode, the register data selected by the map address inputs (MA0
through MA3) will be available on the map outputs (MO0 through
MO7). Note that the map registers are addressed by either the RS
inputs or the MA inputs depending upon the operating mode. When MEN
(Map Enable) is low the map outputs (MO0-MO7) are active. When MEN is
high, the map outputs are at high impedance.
***Versions:...
***Features:...
**SL9010 System Controller (80286/80386SX/DX, 16/20/25MHz) <oct88...
**SL9020 Data Controller <oct88...
**SL9025 Address Controller <oct88...
**SL9090 Universal PC/AT Clock Chip <oct88...
**SL9250 Page Mode Memory Controller (16/20MHz 8MB Max) <oct88...
**SL9350 Page Mode Memory Controller (16/20/25MHz 16MB Max) <oct88...
**Other:...
*Motorola...
*OPTi...
*PC CHIPS/Amptron/Atrend/ECS/Elpina/etc...
*SIS...
*Symphony...
*TI (Texas Instruments)...
*UMC...
*Unresearched:...
*VIA...
*VLSI...
**VL82C386-SET TOPCAT 386DX PC/AT-Compatible Chip Set ?
***Info:
The TOPCAT 386DX chip set from VLSI Technology, Inc., is a very high
integration chip set for use in the design of PC/AT-compatible based
systems. This chip set is intended for use in 80386DX
microprocessor-based systems with clock speeds form 16 to 33 MHz.
The TOPCAT 386DX chip set provides design engineers with a very
flexible, high- performance, low-cost board design solution for IBM
PC/AT-compatible desktop, laptop, portable, and hand-held computers.
The TOPCAT 386DX three-device chip set has been designed with the
highest integration consistent with economic and reliable system
design. It provides a complete board design using only 10 non-memory
devices including the microprocessor.
VLSI's The TOPCAT 386DX chip set was designed with seven goals.
o lowest system board cost
o Smallest board area requirement
o highest performance in both cached and non-cached systems
o single board design for:
- 16 to 33 MHz operation
- Cache or non-cache
- 1M byte to 64M byte memory using 256K, 1M, and 4M bit DRAM
- Laptop or desktop applications
o Full hardware LIM EMS 4.0 support for the highest possible
performance
o Built-in, in-circuit test modes for easy board level testing.
o the VL82C330A interfaces to the VL82C335 "look-aside" Cache
Controller
with VLSI's TOPCAT 386DX chip set, you can be assured that your
high-performance system design needs are met.
***Configuration:...
***Features:...
**VL82C386sx-SET TOPCAT 286/386SX PC/AT-Compatible Chip Set ?...
**VL82C310 SCAMP-LT ?...
**VL82C311 SCAMP-DT ?...
**VL82C311L SCAMP-DT 286 ?...
**VL82C312 SCAMP Power Management Unit (PMU) ?...
**VL82C315A SCAMP II, Low-Power Notebook Chipset ?...
**VL82C322A SCAMP II, Power Management Unit (PMU) ?...
**VL82C316 SCAMP II, PC/AT-Compatible System Controller ?...
**VL82C323 SCAMP II, 5 Volt Power Management Unit (PMU) ?...
**VL82C380 Single chip 386DX PC/AT Controller +on-chip cache ?...
**VL82C325 VL82C386SX System Cache controller ?...
**VL82C335 VL82C386DX System Cache ctrl. [no d.sheet] ?...
**VL82C315A/322A/3216 Kodiak 32-Bit Low-Voltage Chip Set ?...
**VL82C420/144/146 SCAMP IV [no datasheet, some info] c93...
**VL82C480 System/Cache/ISA bus Controller ?...
**VL82C481 System/Cache/ISA bus Controller c92...
**VL82C486 Single-Chip 486, SC486, Controller ?...
**VL82C425 486 Cache controller ?...
**???????? Cheetah 486, PCI [no datasheet] ?...
**VL82C3216 Bus Expanding Controller Cache with write buffer ?...
**VL82C521/522 Lynx/M ?...
**VL82C530 Eagle Ð c95...
**VL82C541/543 Lynx c95...
**VL82C591/593 SuperCore 590 c94...
**VL82C594/596/597 Wildcat c95...
**I/O Chips:
**VL82C106 Combination I/O chip ?...
**VL82C107 SCAMP Combination I/O chip ?...
**VL82C108 TOPCAT Combination I/O chip ?...
**VL82C110 Combination I/O chip ?...
**VL82C113 SCAMP Combination I/O chip ?...
**VL82C114 Combination I/O chip ?...
**Video: ...
**Disk:...
**Modems:...
**Other:...
**Not sure if they actually exist...
*Western Digital...
*Winbond...
*ZyMOS...
*General Sources:...
(c) Copyright mR_Slugs Warehouse - All rights Reserved