[Home] [This version is outdated, a new version is here]
*Title...
*Search:...
*Read Me/FAQ/General Info...
*_IBM...
*ACC Micro...
*ALD...
*ALi...
*AMD . . . . . . . [no datasheets, some info]...
*Chips & Technologies...
*Contaq  . . . . . [no datasheets, some info]...
*Efar Microsystems [no datasheets, some info]...
*ETEQ...
*Faraday...
*Forex . . . . . . [List only, no datasheets found]...
*Intel...
**?????  (Profusion)    c:99
Chips:         
Memory Access Controller (MAC)  
Data Interface Buffer (DIB)
CPUs:          8x P-III Xeon Oct
DRAM Types:    SDRAM PC100 2-way Interleave dual channel
Max Mem:       32GB
ECC/Parity:    ECC
AGP speed:     N/A
Bus Speed:     100
PCI Clock/Bus: 1/3 PCI-66/64



**800 series...
*Headland/G2...
*HMC (Hulon Microelectronics)...
*Logicstar...
*Motorola...
*OPTi...
*PC CHIPS/Amptron/Atrend/ECS/Elpina/etc...
*SIS...
**5595       Pentium PCI System I/O                          <12/24/97
***Notes:...
***Info:...
***Versions:

***Features:...
**950        LPC I/O                                         <07/16/99...
**Other:...
**PII/III/Pro...
**Athlon etc...
*Symphony...
*TI (Texas Instruments)...
**SN74LS610/2 IBM AT: SN74LS610, SN74LS612 Memory Mappers          <84
***Notes:...
***Info:
Each 'LS610  and 'LS612  memory mapper  integrated circuit  contains a
4-line to  16-line decoder, a  16-word by  12-bit RAM, 16  channels of
2-line to 1-line multiplexers, and  other miscellaneous circuitry on a
monolithic chip. Each  'LS610 also contains 12 latches  with an enable
control.

The memory  mappers are designed  to expand a  microprocessor's memory
addressing capability by  eight bits. Four bits of  the memory address
bus (see  System Block Diagram)[see  datasheet] can be used  to select
one of 16 map registers that contain  12 bits each.  these 12 bits are
presented  to the  system memory  address bus  through the  map output
buffers  along with  the  unused  memory address  bits  from the  CPU.
However, addressable memory space  without reloading the map registers
is the  same as would  be available with  the memory mapper  left out.
The  addressable  memory  space  is  increased  only  by  periodically
reloading the  map registers  from the  data bus.   This configuration
lends itself  to memory utilization  of 16 pages of  2^(n-4) registers
each  without reloading  (n -  number of  address bits  available from
CPU).

These  devices have  four modes  of operation:  read, write,  map, and
pass.  Data may be read from  or loaded into the map register selected
by  the register select  inputs (RS0  thru RS3)  under control  of R/W
whenever chip select (CS) is low. The data I/O takes place on the data
bus DO thru D7. The map  operation will output the contents of the map
register selected by the map address  inputs (MA0 thru MA3) when CS is
high and  MM (map mode control)  is low. The 'LS612  output stages are
transparent in this mode, while  the 'LS610 outputs may be transparent
or latched. When CS and MM are both high (pass mode), the address bits
on MA0 thru MA3 appear at M08-MO11, respectively (assuming appropriate
latch control) with  low levels in the other bit  positions on the map
outputs.
***Versions:...
***Features:...
**TACT82000   3-Chip 286 [no datasheet]                            c89...
**TACT82411   Snake  Single-Chip AT Controller                     c90...
**TACT82S411  Snake+ Single-Chip AT Controller [no datasheet]      c91...
**TACT83000   AT 'Tiger' Chip Set (386)                            c89...
**TACT84500   AT Chip Set (486, EISA) [no datasheet, some info]    c91...
**Other:...
*UMC...
*Unresearched:...
*VIA...
*VLSI...
*Western Digital...
*Winbond...
*ZyMOS...
*General Sources:...