[Home] [This version is outdated, a new version is here]
*Title...
*Search:...
*Read Me/FAQ/General Info...
*_IBM...
*ACC Micro...
*ALD...
*ALi...
*AMD . . . . . . . [no datasheets, some info]...
*Chips & Technologies...
*Contaq . . . . . [no datasheets, some info]...
*Efar Microsystems [no datasheets, some info]...
*ETEQ...
*Faraday...
*Forex . . . . . . [List only, no datasheets found]...
*Intel...
**82495XP/490XP Cache Controller / Cache RAM (for i860) 06/05/91
***Notes:...
***Info:...
***Features:...
**82496/491 Cache Controller / Cache RAM (for P5 Pentium) 03/22/93...
**82497/492 Cache Controller / Cache RAM (for P54 Pentium) <Nov94...
**82498/493 Cache Controller / Cache RAM (for P54 Pentium) <Nov94...
**
**Later chipsets (basic spec):
**440 series:...
**450NX (?) 06/29/98:...
**????? (Profusion) c:99...
**800 series...
*Headland/G2...
*HMC (Hulon Microelectronics)...
*Logicstar...
*Motorola...
*OPTi...
**82C802G/GP System/Power Management Controller (cached) c:93
***Notes:...
***Info:...
***Configurations:...
***Features:
[features found only in the 802GP are marked in [] brackets ]
o Processor interface:
- Intel 80486SX, DX, DX2, SLe, DX4, P24T, P24D
- AMD 486SX, DX2, DXL, DXL2, Plus
- Cyrix DX, DX2, M7
- CPU frequencies supported 20, 25, 33, 40 and 50MHz
o Cache interface:
- Direct mapped cache
- Two banks interleaved or single bank non-interleaved
- 64, 128, 256 and 512K cache sizes
- Programmable wait states for L2 cache reads and writes
- 2-1-1-1 read burst and zero wait state write @ 33MHz
- No Valid bit required
[- Supports external single-chip cache modules from thyroid-party ]
[ vendors for high performance at 50MHz ]
- Supports CPUs with L1 write-back support
o DRAM interface:
- Up to 128MB main memory support
- Supports 256KB, 1MB, 4MB, and 16MB single- and double-sided SIMM
modules
- Read page hit timing of 3-2-2-2 at 33MHz
- Supports hidden, slow. and CAS-before-RAS refresh
- Four RAS lines to support four banks of DRAM
[- Eight RAS lines to support four banks of DRAM ]
- Programmable wait states for DRAM reads and writes
[- Programmable memory holes for supporting ISA memory ]
- Enhanced DRAM configuration map
[- Strong drivers on the MA lines (12/24mA) ]
[- Supports asymmetric DRAMs ]
o Power management:
- Support for SMM (System Management Mode) for system power
management implementations
- Programmable power management
[- CPU clock control ]
- Programmable wake-up events through hardware, software, and
external SMI source
- Multiple level GREEN support (NESTED_GREEN)
- STPCLK# protocol support
[- Programmable GREEN event timer ](802G only)
[- Individually programmable peripheral ](802GP only)
o ISA interface:
- 100% IBM PC/AT ISA compatible
[- Programmable edge- or level-trigger interrupts ]
- integrates DMA, timer and interrupt controllers
[- Slew rate control for output drivers ]
- Optional PS/2 style IRQ1 and IRQ12 latching
o VESA VL interface:
- Conforms to the VESA V2.0 specification
- Optional support for up to two VL masters
o Miscellaneous features: (802G only)
- Full support for shadow RAM, write protection, L1/L2
cacheability for video, adapter, and system BIOS
- Enhanced arbitration scheme
- Transparent 8042 emulation for fast CPU reset and GATEA20
generation
o [Miscellaneous features: ](802GP only)
[- Full support for flash, write protection, L1/L2 ]
[ cacheability for video, adapter, and system BIOS ]
[- Provides Micro Channel bridge support ]
[- 10-/16-nit I/O decodes ]
[- Enhanced arbitration scheme ]
o Packaging:
- Higher integration
- Reduced TTL count
- Low-power, high~speed 0.8-micron CMOS technology
- 208-pin PQFP (Plastic Quad Flat Pack)
**82C895 System/Power Management Controller (cached) c:Sep94...
**82C898 System/Power Management Controller (non-cache)c:Nov94...
**
**Support Chips:
**82C601/2 Buffer Devices <Nov94...
**82C822 PCIB (VLB-to-PCI bridge) c:94...
**Other:...
*PC CHIPS/Amptron/Atrend/ECS/Elpina/etc...
*SIS...
*Symphony...
**SL82C465 Cache Controller (for 486/386DX/SX) c:91
***Info:
The SL82C465 cache controller supports both 1X and 2X clock modes. The
1X clock mode means that the CCLK2 signal is used as the CPU clock;
the 2X clock mode means that the PCLK signal (half the frequency and
the phase indicator of CCLK2) is used as the CPU clock. The SL82C465
and other CPU local bus devices run at the same clock frequency as the
CPU, while the rest of the system runs at the frequency of PCLK. In
other words, the operating frequency of the system logic is either the
same (2X clock mode) or half the speed of the CPU (1X clock mode). For
the 1X clock mode, the timing of the signals between the CPU/Cache and
the system logic interface is converted by the SL82C465 automatically
to satisfy the requirement of individual clocks. Table 1-1 [see
datasheet] lists the operating frequencies of the CPU local bus and
the system logic with the oscillator used.
The 2X clock mode is recommended for a CPU frequency no faster than
33Mhz because the system logic is available at the targeted speed and
the performance is slightly better than if 1X clock mode were
used. For a CPU frequency faster than 33Mhz, the 1X clock mode is
preferred for 486 systems because it becomes increasingly more
difficult to build a reliable system with an oscillator faster than
66Mhz.
***Versions:...
***Features:...
*TI (Texas Instruments)...
*UMC...
*Unresearched:...
*VIA...
*VLSI...
*Western Digital...
*Winbond...
*ZyMOS...
*General Sources:...
(c) Copyright mR_Slugs Warehouse - All rights Reserved