[Home] [This version is outdated, a new version is here]
*Title...
*Search:...
*Read Me/FAQ/General Info...
*_IBM...
*ACC Micro...
*ALD...
*ALi...
*AMD . . . . . . . [no datasheets, some info]...
*Chips & Technologies...
*Contaq  . . . . . [no datasheets, some info]...
*Efar Microsystems [no datasheets, some info]...
*ETEQ...
*Faraday...
*Forex . . . . . . [List only, no datasheets found]...
*Intel...
**82395SX     Smart Cache                                     12/17/90
***Notes:...
**82396SX     Smart Cache                                     12/17/90...
**82485       Turbo Cache (and 485Turbocache)                      c90...
**82489DX       Advanced Programmable Interrupt Controller    10/12/92...
**82495DX/490DX DX CPU-Cache Chip Set                           <Sep91...
**82495XP/490XP Cache Controller / Cache RAM (for i860)       06/05/91...
**82496/491     Cache Controller / Cache RAM (for P5 Pentium) 03/22/93...
**82497/492   Cache Controller / Cache RAM (for P54 Pentium)    <Nov94...
**82498/493   Cache Controller / Cache RAM (for P54 Pentium)    <Nov94...
**
**Later chipsets (basic spec):
**440 series:...
**450NX  (?)            06/29/98:...
**?????  (Profusion)    c:99...
**800 series...
*Headland/G2...
**HT18          80386SX Single Chip                            c:Sep91
***Info:...
***Configurations:...
***Features:
o   Highly Integrated, Single Chip 80386SX AT Compatible Solution
o   Special Multiple Context Hardware EMS Support (LIM 4.0 compatible) 
    using 2 sets of 32 EMS Registers
o   Single or Dual BIOS
o   Shadow RAM support over entire C0000 to DFFFF Address range in 16K 
    increments, E0000 to FFFFF in 64K increments
o   Page Mode and 2-way Interleaving
o   Supports up to 12MHz AT Bus Clock
o   High Performance Muxed DRAM Interleave
o   Programmable DRAM timing
o   Asynchronous AT Bus Clock
o   Three-State Test Mode
o   16-Bit ROM BIOS Support

HT 18A/B Special Features
o   16 and 20 MHz CPU Clock Speeds
o   Supports up to 8M CPU Memory using combinations of 64K, 256K and 
    1M Devices
o   4 Bank, 4-way Interleave Mode

HT18C/25MHz Special Features
o   16, 20 and 25MHz CPU Clock Speeds
o   Supports up to 20M with EMS CPU Memory using combinations of 256K, 
    1M and 4M Devices

**HT21          386SX/286 Single Chip (20 MHz)                 c:Aug91...
**HT22          386SX/286 Single Chip (25 MHz)                 c:Sep91...
**HT25          3-volt Core Logic for 386SX                    c:Dec92...
**HT35          Single-Chip Peripheral Controller [partial info]     ?...
**HTK320        386DX Chip Set                                 c:Sep91...
**HTK340        "Shasta" 486 Chip Set                          c:Jun92...
**Support Chips:
**HT44          Secondary Cache                                c:Jun92...
**Other:...
*HMC (Hulon Microelectronics)...
*Logicstar...
*Motorola...
*OPTi...
*PC CHIPS/Amptron/Atrend/ECS/Elpina/etc...
*SIS...
*Symphony...
**SL82C465    Cache Controller (for 486/386DX/SX)                 c:91
***Info:
The SL82C465 cache controller supports both 1X and 2X clock modes. The
1X clock  mode means that the CCLK2  signal is used as  the CPU clock;
the 2X clock  mode means that the PCLK signal  (half the frequency and
the phase indicator  of CCLK2) is used as the  CPU clock. The SL82C465
and other CPU local bus devices run at the same clock frequency as the
CPU, while  the rest of the system  runs at the frequency  of PCLK. In
other words, the operating frequency of the system logic is either the
same (2X clock mode) or half the speed of the CPU (1X clock mode). For
the 1X clock mode, the timing of the signals between the CPU/Cache and
the system logic interface  is converted by the SL82C465 automatically
to  satisfy  the requirement  of  individual  clocks.  Table 1-1  [see
datasheet] lists  the operating frequencies  of the CPU local  bus and
the system logic with the oscillator used.

The 2X  clock mode is recommended  for a CPU frequency  no faster than
33Mhz because the system logic  is available at the targeted speed and
the  performance  is  slightly  better  than if  1X  clock  mode  were
used. For  a CPU  frequency faster  than 33Mhz, the  1X clock  mode is
preferred  for  486  systems  because  it  becomes  increasingly  more
difficult to  build a reliable  system with an oscillator  faster than
66Mhz.

***Versions:...
***Features:...
*TI (Texas Instruments)...
*UMC...
*Unresearched:...
*VIA...
*VLSI...
*Western Digital...
*Winbond...
*ZyMOS...
*General Sources:...