PB600 Flash BIOS Update

BIOS Upgrade Procedure
  1. Insert the BIOS update diskette into drive A: and reboot the system.
  2. The following dialog box will appear:
  3. Press <Enter>
  4. The Main Menu will appear on the screen:
  5. Select "Update Flash Memory Area from a file" using the Down Arrow key.
  6. Press <Enter>.
  7. The UPDATE FLASH AREA dialog box appears on the screen:
  8. Select "Update System Bios".
  9. Press <Enter>.
  10. The following dialog box will appear:
  11. Select 1006AU0R.BIO file.
  12. Press <Enter>.
  13. Press <Enter> at the following screen to proceed with programming.
  14. The following dialog box will appear on the screen:
  15. The following message will appear:
  16. The BIOS is now re-programmed with the updated BIOS file.
  17. Remove the disk from drive A
  18. Press <Enter> to reboot the computer system.
  19. Complete the process by running the CMOS Setup program.

BIOS Recovery

  1. The 'FLASH NORMAL/FLASH RECOVERY' jumper block,J14 is located near the Primary Power Connector,J20/J22.
  2. Move the 'FLASH NORMAL/FLASH RECOVERY' jumper block,J14 from pins 2-3 to pins 1-2.
  3. Insert the BIOS upgrade diskette and reboot the system. No video is available during the procedure.
  4. The system beeps once and starts copying the recovery code into the CMOS Flash memory.
  5. The system beeps twice as the recovery completes.
  6. Turn off the system and move the jumper block J14 from pins 1-2 to pins 2-3.
  7. Leave the BIOS upgrade diskette in the floppy drive, and continue with the original upgrade following the procedure described in 'BIOS UPGRADE PROCEDURE'.