Document Number: 107315-025, Volume 1
Publication Date: January 1996
| System Boards | Assembly | Spare Part | Config Code | System |
| System Board | 003651 | 164560-001 1,2 | HKA | ProLinea 4/33s |
| 003857 | HKB | ProLinea 4/50s | ||
| 003759 | HKC | ProLinea 4/50 | ||
| 003760 | HKD, HNE | ProLinea 4/66 | ||
| System Board | 003761 | 164561-001 1 | HKE | ProLinea 4/100 |
| Backplane | 002927 | 141783-001 | -- | All
|
|
1 System board spares do not contain the processor. Remove the processor in the end user's system and install it on the spare part. Check the jumper configurations for proper setup.
2 These boards supply 5 volt power to the processor socket. Do not install a 3 volt processor (Intel DX4/100) on these system boards. It will result in processor failure. |
| Header ID | Function | Pins Jumpered | Settings Function |
| P5, 6 | Onboard video
enable/disable | 1, 2*
No jumpers | Enabled
Disabled |
| P7 | Pentium OverDrive TM
Write Back Control | 1, 2
2, 3* | Write Through Mode
Write Back Mode |
| P8 | Speed Select | 1, 2
2, 3 | 25 MHz Processor Bus
33 MHz Processor Bus |
| P10 | Processor Configuration | 1, 2
2, 3 | 486SX Installed
Other than 486SX installed |
| P11 | Printer Interrupt Selection | 1, 2*
2, 3 | Printer Interrupt = IRQ7
Printer Interrupt = IRQ5 |
| P12, 13 | ECP DMA Channel Selection | 1, 2*
2, 3 No Jumpers | ECP uses DMA channel 0
ECP uses DMA channel 3 ECP DMA disabled |
| P14 | Clear Password and Setup | 1, 2 | Remove jumper for 10 seconds to clear CMOS |
| P15 | Intel DX4 Internal Processor Speed | 1, 2
2, 3 3, 4 | Processor runs at 2.5 times clock speed
Processor runs at 2 times clock speed
Processor runs at 3 times clock speed
|
|
* Default |
| Microprocessors | Assembly | Spare Part | System |
| 486SX/33 | 003651 | 164563-001 | ProLinea 4/33s |
| 486SX2/50 | 003857 | 164564-001 | ProLinea 4/50s |
| 486DX2/50 | 003759 | 163661-001 | ProLinea 4/50 |
| 486DX2/66 | 003760 | 194395-001 | ProLinea 4/66 |
| 486DX4/100 | 003761 1 | 164592-001 | ProLinea 4/100
|
|
1 CAUTION: Do not install this processor in 5 volt processor boards. It will result in processor failure. This is a 3 volt chip.
|
| Memory | Spare Part |
| 2 MB Memory Module | 141753-001 |
| 4 MB Memory Module | 141754-001 |
| 8 MB Memory Module | 141755-001 |
| 16 MB Memory Module | 149947-001 |
| 32 MB Memory Module | 149948-001 |
| 128 K cache | 197005-001
|
| Size | Type | Interleave | Integrated | Spare Part |
| 170 MB | 65/66 | 1:1 | Y | 194367-001 |
| 200 MB | 51 | 1:1 | Y | 160702-001 |
| 270 MB | 65 | 1:1 | Y | 197441-001 |
| 340 MB | 63 | 1:1 | Y | 171923-001 |
| 420 MB | 65 | 1:1 | Y | 172193-001 |
| 525 MB | 42 | 1:1 | Y | 197014-001 |
| 550 MB SCSI-2 | N/A | -- | -- | 142038-001 |
| 1.05 GB SCSI-2 | N/A | -- | -- | 192799-001
|
| Tape Drives | Spare Part | Tape Cartridge | Spare Part |
| 60 MB (1/3 Height) * | 112524-001 | 40 MB (DC2000)
60 MB (DC2060) | 108142-001 122086-001 |
| 80/120 MB (1/3 Height)* | 131337-001 | 80 MB (DC2080) 120 MB (DC2120) | 116966-001 116967-001 |
| 80/120 MB (1/2 Height)* | 122087-001 | 80 MB (DC2080) 120 MB (DC2120) | 116966-001 116967-001 |
| 120/250 MB (1/2 Height)* | 197490-001 | 120 MB (DC2120) | 116967-001
|
|
* With compression. |
| Diskette Drives | Spare Part | System |
| 1.2 MB | 141367-002 | Option |
| 1.44 MB 3-Mode | 147243-001 | All 486
|
| Cables | Used With | Spare Part |
| Hard Drive Cable | All Drives | 141187-001 |
| Diskette Drive Cable | 1.44 Diskette | 141186-001 |
| LED Cable | -- | 141346-001
|
| Controller Boards | Assembly | Spare Part | System |
| See ProLinea Desktop Family for controllers | |||
| SCSI ISA, Plug and Play | 184750-001 | 184751-001 | Enhanced
|
| ROM Information | Revision | Spare Part |
| System 486Z1 | 07-31-94 | 164562-001
|
| Power Supply/Battery | Spare Part |
| Power Supply | 194352-001 |
| Clock/Battery * (4.5 V, 600 mA) | 160274-001
|
| * When installing this clock battery spare kit, original battery must be disabled. See MSG or User Guide. |
