Deskpro

Document Number: 107315-025, Volume 1
Publication Date: January 1996

SERVICE SUPPORT DISCONTINUED

System Boards AssemblySpare Part
8086 System Board000058
000315
000364
Not Available

BOARD JUMPER/SWITCH SETTINGS

8086 System Board SW1 Switch Settings (000058, 000315, 000364)
12 34 56 78 Function
OFF Reserved (always off)
ON No coprocessor (default)
OFF Coprocessor installed
ON ON 640 KB memory (default)
OFF ON 512 KB memory
OFF OFF 256 KB memory
ON OFF 128 KB memory
ONOFF 80 x 25 Compaq VDU primary. Third party monochrome (MDA only) secondary (default)
OFFON 40 x 25 Compaq VDU * primary. Third party monochrome (MDA only) secondary
ONON 80 x 25 Compaq EGA, compatible EGA, VGA or RGBI primary. Third party monochrome (MDA only) secondary
OFFOFF Third party monochrome (MDA only) primary. RGBI secondary
ON ONOne diskette drive (default)
OFF ONTwo diskette drives
ON OFFThree diskette drives
OFF OFFFour diskette drives
* With a Revision F or later system ROM.

Memory Chips Spare Part
64K x 1 (150 ns) DRAM 105152-001
64K x 4 (150 ns) DRAM Not Available
256K x 1 (150 ns) DRAM 105151-001

Controller Boards AssemblySpare Part
Hard Drive Controller Board WD1002SWX2

WD1002HX4

WD1002WX2

Not Available
Diskette/Printer Board 000043Not Available
Diskette/Printer Board * 000181-011Not Available
* See Volume 2 Appendix, Multiproduct Boards, for settings.

Hard Drive Controller Board Switch Settings (WD1002SWX2)
DriveSW1 for Drive D SW1 for Drive C
1 23 4
10 MBOFF OFFOFF OFF
20 MBON OFFON OFF
30 MBON ONON ON

Hard Drive Controller Board Jumper Settings (WD1002WX2, WD1002HX4) * **
DriveSW1 for Drive D SW1 for Drive C
1 23 4
10 MBON ONON ON
20 MBOFF ONOFF ON
30 MBOFF OFFOFF OFF
* Do not remove jumpers E17 - E18.
** Earlier versions of this board have no switch settings and are fixed for 10 MB.

Video Boards AssemblySpare Part
Enhanced Color Graphics Board (EGA/CECGB) * ** 000410Not Available
Enhanced Color Graphics Board (EGA/CECGB) * ** 000471109196-001
Video Display Controller Board
(VDU) **
000031,
000160,
000345,
000525
101340-001
Video Graphics Controller Board (VGC/VGA) * ** 000806,
001241,
109360
109253-001
* ECG and VGC require system ROM H or later.
** See Volume 2 Appendix, Multiproduct Boards, for settings.

Hard Drives
SizeType Interleave Integrated Minimum ROMSpare Part Controller Assembly
10 MB1 * 4:1No ENot Available WD1002SWX2
WD1002WX2
WD1002HX4
20 MB2 * 4:1No ENot Available WD1002SWX2
WD1002WX2
WD1002HX4
30 MB6 * 3:1No FNot Available WD1002SWX2
WD1002WX2
WD1002HX4
* Drive types are set by switch settings on the hard drive controller board or are hardwired, depending on the hard drive controller used.

Tape Drives Spare PartTape Cartridge Spare Part
10 MBNot Available 10 MB (DC1000)Not Available

Diskette Drives Spare Part
360 KB102928-001 (black bezel)

120329-001 (gray bezel)

Miscellaneous AssemblySpare Part
Asynchronous Communications Clock Board * 000061Not Available
Serial/Parallel Interface Board * 000570

000990

106886-001
2400 Baud Internal Modem 001070Not Available
* See Volume 2 Appendix, Multiproduct Boards, for settings.

Cables
Cable Function Where UsedSpare Part
Diskette/Tape Signal * All Diskette Drives 10 MB Tape Drive 101380-002 (Y Connector)
Mass Storage Power * All Diskette Drives Tape Drives, and Hard Drives 101137-001
Hard Drive Signal20 MB Hard Drive 30 MB Hard Drive 100625-003 (34 Pin)

100625-004 (20 Pin)

* Part of kit 108146-001.

Processor/Coprocessor/ROM Location
8086-2 ProcessorU52
8087-2 Coprocessor U44
System ROMU21

System ROM Revisions (Spare Part not available)
RevisionPN on ROM
E100298-004
F100298-005
G105681-001
H106265-001
J106265-002

Power Supply/Battery Spare Part
Power Supply102927-001 (110V)
102342-001 (220V)
Battery (Mounted on the Asynchronous Communications Clock Board) 131105-001

Home Page Search Table of Contents Help Comments

Compaq Online

© Copyright 1994, 1995, 1996 Compaq Computer Corporation.
Revised: 06 September 1996