[Home] [This version is outdated, a new version is here]
*Title...
*Search:...
*Read Me/FAQ/General Info...
*_IBM...
*ACC Micro...
*ALD...
*ALi...
*AMD . . . . . . . [no datasheets, some info]...
*Chips & Technologies...
*Contaq  . . . . . [no datasheets, some info]...
*Efar Microsystems [no datasheets, some info]...
*ETEQ...
*Faraday...
*Forex . . . . . . [List only, no datasheets found]...
*Intel...
**?????  (Profusion)    c:99
Chips:         
Memory Access Controller (MAC)  
Data Interface Buffer (DIB)
CPUs:          8x P-III Xeon Oct
DRAM Types:    SDRAM PC100 2-way Interleave dual channel
Max Mem:       32GB
ECC/Parity:    ECC
AGP speed:     N/A
Bus Speed:     100
PCI Clock/Bus: 1/3 PCI-66/64



**800 series...
*Headland/G2...
*HMC (Hulon Microelectronics)...
*Logicstar...
*Motorola...
*OPTi...
*PC CHIPS/Amptron/Atrend/ECS/Elpina/etc...
*SIS...
**5581/5582      (Jessie)  Pentium PCI/ISA Chipset (75MHz)   <04/15/97
***Info:
Nowadays, several PC  form factors exist in the  PC board market, such
as  NLX, LPX,  ATX  and Baby-AT  form  factors. Due  to the  different
placements  of the  form factor,  PC chipsets  should be  prepared for
different board  layouts. As a  result, SiS chips based  on compatible
logic design provide two series of chipsets, SiS 5581 and SiS 5582, to
assist board designers for their board layouts.

SiS 5581’s pin assignment is based  on NLX, and LPX form factor, while
SiS 5582’s is defined on the basis of ATX and Baby-AT form factors. In
the next few chapters, you will read "SiS Chip" which indicates either
SiS 5581 or  5582 chipsets, decided by the  placements of form factors
on  PC boards  of customers.   The  SiS Chip  consists of  Host-to-PCI
bridge  function,  PCI  to  ISA  bridge function,  PCI  IDE  function,
Universal Serial Bus host/hub  function, Integrated RTC and Integrated
Keyboard Controller.

SiS Chip  supports Enhanced  Power Management, including  legacy Power
Management  Unit  and   Advanced  Configuration  and  Power  Interface
(ACPI).  It also  supports ATA  Synchronous DMA  transfer  protocol to
improve  the IDE performance  and Common  Architecture for  moving ISA
function to PCI to improve system performance.

***Configuration:...
***Features:...
**5591/5592/5595 (David)   Pentium PCI A.G.P. Chipset        <01/09/98...
**5596/5513      (Genesis) Pentium PCI Chipset               <03/26/96...
**5597/5598      (Jedi)    Pentium PCI/ISA Chipset           <04/15/97...
**530/5595       (Sinbad) Host, PCI, 3D Graphics & Mem. Ctrl.<11/10/98...
**540            (Spartan) Super7 2D/3D Ultra-AGP Single C.S.<11/30/99...
**55x            SoC (System-on-chip)                        <03/14/02...
**
**Support chips:
**85C206     Integrated Peripheral Controller [no datasheet]         ?...
**5595       Pentium PCI System I/O                          <12/24/97...
**950        LPC I/O                                         <07/16/99...
**Other:...
**PII/III/Pro...
**Athlon etc...
*Symphony...
*TI (Texas Instruments)...
*UMC...
*Unresearched:...
*VIA...
*VLSI...
*Western Digital...
**WD76C30x   Perip. Ctrl, Interrupt Multiplex, and Clock Gen <11/18/91
***Notes:...
***Info:...
***Versions:...
***Features:
o   Two fully programmable and independent serial I/O ports 
    configurable as PC/AT compatible (WD16C452) or PS/2 
    compatible (WD16C552)
    - Loopback controls for communications link fault isolation for 
      each ACE
    - Line break generation and detection for each ACE
    - Complete status reporting capabilities
    - Generation and stripping of serial asynchronous data control 
      bits (start, stop, parity)
    - Programmable baud rate generator and MODEM control signals for 
      each port
    - Programmable baud rate generator input clock
    - Optional 16 byte FIFO buffers on both transmit and receive of 
      each port for CPU relief during high speed data transfer
    - Programmable FIFO threshold levels of 1 , 4, 8, or 14 bytes on 
      each port
o   Parallel port configurable as a fully Centronics or PS/2 
    compatible, bidirectional parallel port
o   Independently programmable parallel port
o   Interrupt multiplexing logic
    - Selectable multiplexing logic for connecting PC/AT interrupt 
      request lines to the WD76C10 single chip AT controller
o   Clock generation circuitry
    - 80287 coprocessor clock generation
    - WD76C10 and floppy controller clock generation
    - 8042 keyboard clock generation
o   Built-in testability features
o   Hardware or software controllable sleep mode
o   CMOS implementation for high speed and low power requirements 
o   Pulse extension on IRQ inputs
o   84-pin PLCC and PQFP packages

**WD7615     Desktop Buffer Manager                          <04/15/92...
**WD7625     Desktop Buffer Manager                          <10/01/92...
**WD8120LV   Super I/O [no datasheet]                                ?
**Other Chips:...
*Winbond...
*ZyMOS...
*General Sources:...