[Home] [This version is outdated, a new version is here]
*Title...
*Search:...
*Read Me/FAQ/General Info...
*_IBM...
*ACC Micro...
*ALD...
*ALi...
*AMD . . . . . . . [no datasheets, some info]...
*Chips & Technologies...
*Contaq . . . . . [no datasheets, some info]...
*Efar Microsystems [no datasheets, some info]...
*ETEQ...
*Faraday...
*Forex . . . . . . [List only, no datasheets found]...
*Intel...
**????? (Profusion) c:99
Chips:
Memory Access Controller (MAC)
Data Interface Buffer (DIB)
CPUs: 8x P-III Xeon Oct
DRAM Types: SDRAM PC100 2-way Interleave dual channel
Max Mem: 32GB
ECC/Parity: ECC
AGP speed: N/A
Bus Speed: 100
PCI Clock/Bus: 1/3 PCI-66/64
**800 series...
*Headland/G2...
**HT11 Single 286 AT Chip [no datasheet] <Aug90
***Notes:...
**HT12/+/A Single 286 AT Chip with EMS support c:Aug90...
**HT18 80386SX Single Chip c:Sep91...
**HT21 386SX/286 Single Chip (20 MHz) c:Aug91...
**HT22 386SX/286 Single Chip (25 MHz) c:Sep91...
**HT25 3-volt Core Logic for 386SX c:Dec92...
**HT35 Single-Chip Peripheral Controller [partial info] ?...
**HTK320 386DX Chip Set c:Sep91...
**HTK340 "Shasta" 486 Chip Set c:Jun92
***Notes:...
***Info:
The HTK340 chip set is a two chip, high performance, cost-effective
solution for the 80486SX DX, and DX2 processing environments. In its
minimum configuration, this highly integrated chip set requires only
four external TTL devices to implement a fully compatible IBM PC/AT
system at speeds up to 33MHZ.
The HTK340 is based upon Headland's HTK320 Bus Architecture and
consists of the HT321-ISA Bus Controller and the HT342-Memory Control
Unit (MCU). Both chips are packaged in 184 pin plastic quad flat
packs.
The HTK340 is unique in that it provides performance approximating
that of large secondary cache systems, including the highest
performance write back cache architectures, without any external
cache. Secondary cache solutions should be considered in applications
that make use of multi-tasking and large model operating systems. The
Headland HT44 secondary cache was designed to meet the cost and
performance objectives for these applications. The key to this level
of performance is the 4-level deep write buffer, which includes byte
gathering for up to 32-bit DRAM writes.
Due to the effectiveness of the primary cache internal to the 80486
most of the bus activity in a PC/AT compatible environment consists of
writes. Indeed, this write activity consists almost exclusively of
writes of either bytes or Words (16 bit entities). In addition, much
of this write activity is into sequential memory locations. The byte
gathering feature of the buffer has the effect of reducing the number
of memory accesses required. Since the 80486 can always write into the
buffer with zero wait states (assuming the buffer is not full), and
the buffer can empty faster than it can be filled for most write
activity, the net effect is that the writes from the CPU never cause a
wait state.
The HTK340 can support Peripheral Devices such as VGA or SCSI on the
local processor bus, or any other devices that are designed to work
within the 80486 bus protocol and timing. By eliminating the ISA
backplane bottleneck, system designers can greatly improve the
performance of functions such as graphics generation and disk access.
The HTK340 supports up to 4 banks of DRAM, configurable as 1-4
banks. This flexible memory architecture allows for any memory type,
from 256K to 16M devices, in any bank. Maximum system performance is
achieved from the DRAM banks through various means, including
interleaving of memory banks and/or paging, and CAS before RAS
refresh. The memory can also be tuned to maximum potential through the
use of extensive DRAM timing control registers. These controls
include: precharge time, access time on reads, active time on writes,
as well as CAS and RAS delays. In addition, further system perfor-
mance is gained by separate timing parameters on the read and write
cycles which allow system designers to take maximum advantage of the
pipelined structure of the chip set.
The HTK340 also supports extensive mapping registers, which allow
system designers to take maximum advantage of system memory. The chip
set supports Shadow/Remap in 16K blocks between the 640K and 1M
boundaries, and eliminates the requirement for external decoding logic
by supporting 26 programmable non-cache regions. Devices which meet
HTK340 local bus requirements may be implemented without external
TTL. The mapping structure of the HTK340 provides for a single 8-bit
EPROM to be used for both the System and Video BIOS, further reducing
system chip count and cost.
***Configurations:...
***Features:...
**Support Chips:
**HT44 Secondary Cache c:Jun92...
**Other:...
*HMC (Hulon Microelectronics)...
*Logicstar...
*Motorola...
*OPTi...
*PC CHIPS/Amptron/Atrend/ECS/Elpina/etc...
*SIS...
*Symphony...
*TI (Texas Instruments)...
*UMC...
*Unresearched:...
**J - R
***Micro Integration...
***Micron...
***Oak...
***Other:...
**S...
**T - Z...
*VIA...
*VLSI...
*Western Digital...
*Winbond...
*ZyMOS...
*General Sources:...
(c) Copyright mR_Slugs Warehouse - All rights Reserved