BOARD			; 12/04 fcm Chg
 ID="WTT0004"
 NAME="Wangtek PC-36 QIC HOST ADAPTER/ASSY 30475"
 MFR="Wangtek"
 CATEGORY="MSD"
 SLOT=ISA16
; LENGTH=343   HEIGHT=107
 READID=NO
 COMMENTS="The Wangtek PC-36II Controller is designed to interface with the
	Wangtek Series 5000E and Series 5125E Basic Drives via the QIC-36
	basic streaming tape drive interface." 
SWITCH(1) = 10
  NAME = "SW-1"
  STYPE = DIP
  VERTICAL = NO
  REVERSE = YES
  FACTORY = LOC(1-10)1111111000


JUMPER(1)=1
 NAME="W1"
 JTYPE=PAIRED
 VERTICAL= NO
 REVERSE=YES
 INITVAL=LOC(1) 1
 COMMENTS = "The normal setting is jumpered."
		
JUMPER(8) = 3
 NAME="DRQ 1-3"
 JTYPE = PAIRED
 VERTICAL=NO
 REVERSE = NO
 LABEL = LOC(1-3)"1" "2" "3"
 FACTORY = LOC(1-3)100
 COMMENTS="A jumper setting on DRQ1 is standard.  These settings are used
	to select the DMA channel requests.  DRQ1 has the highest priority"

JUMPER(10) = 3
 NAME="DACK 1-3"
 JTYPE = PAIRED
 VERTICAL = NO
 REVERSE = NO
 LABEL = LOC(1-3)"1" "2" "3"
 FACTORY = LOC(1-3) 100
 COMMENTS = "DACK1-DACK3 jumpers are used to select the DMA acknowledge line.
		A jumper setting on DACK1 is standard."

JUMPER(12) = 6
 NAME = "IRQ 2-7"
 JTYPE = PAIRED
 VERTICAL = NO
 REVERSE = YES
 LABEL = LOC(1-6) "2" "3" "4" "5" "6" "7"
 FACTORY = LOC(1-6) 010000
 COMMENTS = "IRQ 2-7 jumpers are used to select the interrupt request lines.  
	IRQ2 has the highest priority and IRQ7 has the lowest.  The standard
	setting is IRQ3." 
FUNCTION = "Option selection"
SUBFUNCTION = "Port Selection"
	CHOICE="Port Addresses"
	LINK
	PORT = 300H|000h|2ACh|3F6h|338h
        INIT=SWITCH(1) LOC(1-10)1111111000|1111111110|1001010100|
		0010000000|1100011000
SUBFUNCTION = "DMA Selection"
	CHOICE = "DMA Address"
	LINK
	DMA = 1|2|3
	INIT=JUMPER(8)LOC(1-3)100|010|001
	INIT=JUMPER(10)LOC(1-3)100|010|001
SUBFUNCTION = "IRQ Selection"
	CHOICE = "IRQ Address"
	LINK
	IRQ = 3|2|4|5|6|7
	INIT=JUMPER(12)LOC(1-6)010000|100000|001000|000100|000010|000001