; EISA Configuration File for Computone IntelliPort II EISA-8 ; Revision History: ; 3/20/92 MAG First Draft ; 5/28/92 MAG Warning in interrupt help about sharing interrupts ; between ISA and EISA controllers. ; 12/15/93 MAG PORTVAR removed, ; Config Disk's Version number added to HELP ; Order of Interrupt choices changed ; BOARD ID = "CTN0218" NAME = "IntelliPort-II (EISA-8)" MFR = "Computone Corporation" CATEGORY = "COM" AMPERAGE = 1600 SLOT = EISA LENGTH = 180 SKIRT = NO READID = YES IOCHECK = INVALID DISABLE = SUPPORTED COMMENTS = "The Computone IntelliPort-II EISA-8 supports up to eight asynchronous serial ports. This board uses only EISA slot-dependent i/o addresses, and an interrupt which is automatically configured." HELP = "Option/Configuration Disk, Version 2.06\n Select IRQ. The i/o address depends on the slot you have chosen." IOPORT(1) = 0ZC86h SOFTWARE(1) = "Drivers are available to support:\n SCO Xenix and Unix\n AT&T / Interactive Unix (3.2)\n UNIX System V release 4\n The drivers are supplied on separate diskette. Refer to our manual as well as the manuals for your o/s for driver installation information.\n Please make note which interrupt and slot you have selected; you may need this during driver installation." FUNCTION = "Computone IntelliPort-II (EISA-8)" CONNECTION = "Uses HD62 Connector to external passive distribution box.\n Signals:\n TxD, RxD, DTR, DCD, CTS, RTS" TYPE = "COM" SUBFUNCTION = "Interrupt" COMMENTS= "Select the irq this board is to use. Record your selection; you will need to provide this information when installing software drivers.\n For more details, select [help]." HELP= "This utility will configure the board to use the interrupt that you select, but the software drivers may also need to know this.\n When installing multiple IntelliPort-II boards, use the same interrupt for all. (Exception: ISA IntelliPort-II boards cannot share an interrupt with EISA IntelliPort-II boards.) Not all drivers will support polled (non-interrupt) operation." CHOICE = "IRQ10" LINK IRQ = 10 SHARE = "CTN.EII" TRIGGER = LEVEL INIT = IOPORT(1) 00001100b CHOICE = "IRQ11" LINK IRQ = 11 SHARE = "CTN.EII" TRIGGER = LEVEL INIT = IOPORT(1) 00001101b CHOICE = "IRQ12" LINK IRQ = 12 SHARE = "CTN.EII" TRIGGER = LEVEL INIT = IOPORT(1) 00001110b CHOICE = "IRQ15" LINK IRQ = 15 SHARE = "CTN.EII" TRIGGER = LEVEL INIT = IOPORT(1) 00001111b CHOICE = "IRQ3" LINK IRQ = 3 SHARE = "CTN.EII" TRIGGER = LEVEL INIT = IOPORT(1) 00001000b CHOICE = "IRQ4" LINK IRQ = 4 SHARE = "CTN.EII" TRIGGER = LEVEL INIT = IOPORT(1) 00001001b CHOICE = "IRQ5" LINK IRQ = 5 SHARE = "CTN.EII" TRIGGER = LEVEL INIT = IOPORT(1) 00001010b CHOICE = "IRQ7" LINK IRQ = 7 SHARE = "CTN.EII" TRIGGER = LEVEL INIT = IOPORT(1) 00001011b CHOICE = "Polled (No interrupt used)" LINK INIT = IOPORT(1) 00000000b